The dynamic behavior of axons in systems that normally regenerate may provide clues for promoting regeneration in humans. When the optic nerve is severed in adult goldfish, all axons regenerate back to the tectum to reestablish accurate connections. In adult mammals, regeneration can be induced in optic and other axons but typically few fibers regrow and only for short distances. These conditions were mimicked in the adult goldfish by surgically deflecting 10-20% of optic fibers from one tectum into the opposite tectum which was denervated of all other optic fibers by removing its corresponding eye. At 21-63 days, DiI was microinjected into retina to label a few fibers and the fibers were visualized in the living fish for up to 5-7 h. The dynamic behavior and morphology of these regenerating deflected fibers were analyzed and compared to those regenerating following optic nerve crush. At 3-4 weeks, deflected fibers were found to form more branches and to maintain many more branches than crushed fibers. Although both deflected and crushed fibers exhibited stochastic growth and retraction, deflected fibers spent more time growing but grew for less distance. At 2 months, both deflected and crushed fibers became much more stable. These results show that the morphology and behavior of fibers regenerating into the same target tissue can be substantially altered by the injury conditions, that is, they show state-dependent plasticity. The morphology and behavior of the deflected fibers suggest they were impaired in their capacity to grow to their correct targets.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC2377195PMC
http://dx.doi.org/10.1016/j.expneurol.2007.12.006DOI Listing

Publication Analysis

Top Keywords

deflected fibers
16
fibers
14
optic fibers
12
crushed fibers
12
morphology regenerating
8
regenerating optic
8
fibers tectum
8
altered injury
8
injury conditions
8
dynamic behavior
8

Similar Publications

Improving the Long-Term Mechanical Properties of Thermoplastic Short Natural Fiber Compounds by Using Alternative Matrices.

Biomimetics (Basel)

January 2025

Macromolecular Chemistry and New Polymeric Materials, Zernike Institute for Advanced Materials, University of Groningen, Nijenborgh 3, 9747 AG Groningen, The Netherlands.

Wood plastic composites (WPCs) offer a means to reduce the carbon footprint by incorporating natural fibers to enhance the mechanical properties. However, there is limited information on the mechanical properties of these materials under hostile conditions. This study evaluated composites of polypropylene (PP), polystyrene (PS), and polylactic acid (PLA) processed via extrusion and injection molding.

View Article and Find Full Text PDF

Improvement of Bending Stiffness of Timber Beams with Ultra-High-Modulus-Carbon-Fibre-Reinforced Polymer Sheets.

Materials (Basel)

December 2024

Department of Theory of Structures and Building Information Modeling (BIM), Faculty of Civil Engineering and Architecture, Kielce University of Technology, Al. Tysiaclecia Panstwa Polskiego 7, 25-314 Kielce, Poland.

The bending stiffness of beams represents a pivotal parameter influencing both the dimensions of the elements during their design and their subsequent utilisation. It is evident that excessive deflections can cause discomfort to users and contribute to further structural degradation. The objective of this study was to enhance the bending stiffness of timber beams by bonding a composite sheet to their external surfaces.

View Article and Find Full Text PDF

This study explores the potential of using underutilized materials from agricultural and forestry systems, such as rice husk, wheat straw, and wood strands, in developing corrugated core sandwich panels as a structural building material. By leveraging the unique properties of these biobased materials within a corrugated geometry, the research presents a novel approach to enhancing the structural performance of such underutilized biobased materials. These biobased materials were used in different lengths to consider the manufacturing feasibility of corrugated panels and the effect of fiber length on their structural performance.

View Article and Find Full Text PDF

The adoption of pultruded glass fibre-reinforced polymer (pGFRP) composites as a substitute for traditional wooden cross-arms in high transmission towers represents a relatively novel approach. These materials were selected for their high strength-to-weight ratio and lightweight properties. Despite various studies focusing on structures improvement, there still have a significant gap in understanding the deformation characteristics of full-scale cross-arms under actual operational loads.

View Article and Find Full Text PDF

In diagnosing and treating prostate cancer the flexible bevel tip needle insertion surgical technique is commonly used. Bevel tip needles experience asymmetric loading on the needle's tip, inducing natural bending of the needle and enabling control mechanisms for precise placement of the needle during surgery. Several methods leverage the needles natural bending to provide autonomous control of needle insertion for accurate needle placement in an effort to reduce excess tissue damage and improve patient outcomes from needle insertion intraventions.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!