Fast pyrolysis of chicken manure produced the following three fractions: bio-oil Fraction I, bio-oil Fraction II, and a char. In a previous investigation we analyzed each of the four materials by curie-point pyrolysis-gas chromatography/mass spectrometry (CpPy-FDMS). The objective of this article is to report on the analyses of the same chicken manure and the three fractions derived from it by fast pyrolysis. We now used pyrolysis-field ionization mass spectrometry (Py-FIMS) to characterize the three fractions. In addition, the two bio-oil materials were analyzed by pyrolysis-field desorption mass spectrometry (Py-FDMS). The use of both Py-FIMS and Py-FDMS produced signals over significantly wider mass ranges than did CpPy-GC/MS, and so allowed us to identify considerably larger numbers of constituents in each material. Individual compounds identified in the mass spectra were classified into the following twelve compound classes: (a) low molecular weight compounds (< m/z 62); (b) carbohydrates; (c) phenols + lignin monomers; (d) lignin dimers; (e) n-alkylbenzenes; (f) N-heterocyclics; (g) n-fatty acids; (h) n-alkanes; (i) alkenes; (j) sterols; (k) n-diols and (l) high molecular weight compounds (> m/z 562). Of special interest were the high abundances of low-molecular weight compounds in the two bio-oils which constituted close to one half of the two bio-oils. Prominent among these compounds were water, ammonia, acetic acid, acetamide, propyl radical, formamide and hydrogen cyanide. The main quantitative differences between the two bio-oils was that bio-oil Fraction I, as analyzed by the two mass spectrometric methods, contained lower concentrations of low-molecular weight compounds, carbohydrates, and N-heterocyclics than bio-oil Fraction II but was richer in lignin dimers, n-alkylbenzenes and aliphatics (n-fatty acids, n-alkanes, alkenes, and n-diols). Of special interest were the N-heterocyclics in the two bio-oils such as pyrazole, pyrazoline, substituted pyrroles, pyridine and substituted pyridines, substituted methoxazole, substituted pyrazines, indole and substituted indoles. Fatty acids in all four materials ranged from n-C(9) to n-C(33), alkanes from n-C(9) to n-C(40), alkenes from C(10:1) to C(40:1) and diols from n-C(7) to n-C(29). The chicken manure, bio-oil Fraction I, and char each contained about 4% sterols with cholesterol, ethylcholestriene, ergosterol, ethylcholestene, ethylcholesterol and beta -sitosterol as major components. Semi-quantitative estimates of the total materials identified by Py-FIMS were: chicken manure: 61.1%; bio-oil Fraction I: 81.3%; bio-oil Fraction II: 78.6%; char: 61.3%; and by Py-FDMS were: bio-oil Fraction I: 65.4%; bio-oil Fraction II: 70.0%.

Download full-text PDF

Source
http://dx.doi.org/10.1080/03601230701735185DOI Listing

Publication Analysis

Top Keywords

bio-oil fraction
36
chicken manure
24
weight compounds
16
fast pyrolysis
12
three fractions
12
bio-oil
11
fraction
9
manure bio-oil
8
analyses chicken
8
py-fims py-fdms
8

Similar Publications

Organosolv-derived lipids from hemicellulose and cellulose, and pre-extracted tannins as additives upon hydrothermal liquefaction (HTL) of spruce bark lignins to bio-oil.

BMC Biotechnol

November 2024

Biochemical Process Engineering, Division of Chemical Engineering, Department of Civil, Environmental and Natural Resources Engineering, Luleå University of Technology, Luleå, SE-971 87, Sweden.

Article Synopsis
  • The study explores using spruce bark, a largely untapped resource, to produce bio-oil, a renewable energy source, as a response to rising global temperatures and petroleum waste issues.
  • It utilizes a process called hydrothermal liquefaction, enhancing bio-oil quality by extracting polysaccharides and converting them into lipids with the help of specific microorganisms.
  • Results showed that pre-extracting tannins and modifying the heating rates in the production process improved the energy content and yield of the bio-oil while reducing its oxygen content.
View Article and Find Full Text PDF

With the increasing emphasis on sustainable manufacturing practices, eco-friendly lubricants have gained significant attention to moderate the friction coefficient at the tool-work interface. In line with this, the contemporary study aimed to examine the viability of Alumina-enriched sunflower bio-oil as a metalworking fluid. Different volume fractions of Alumina nanoparticles (varying from 0 to 1 vol%) were mixed with sunflower bio-oil, and the physical properties, for instance, contact angle and dynamic viscosity, were analyzed to determine the optimal concentration of Alumina.

View Article and Find Full Text PDF

Renewable Fuels and Chemical Recycling of Plastics via Hydrothermal Liquefaction.

Acc Chem Res

December 2024

Penn State University, Chemical Engineering Department, University Park, Pennsylvania 16802, United States.

Article Synopsis
  • Hydrothermal liquefaction (HTL) is a process that converts various biomass types into renewable bio-oil through reactions in hot, compressed water, producing additional gas and solid products.
  • The process retains a substantial amount of chemical energy, recovering around 70-80% of it in an oil that weighs only 20-50% of the original biomass, though the bio-oil often requires further upgrading to be usable as fuel.
  • HTL can also convert different plastics into oil, achieving high yields with certain types while being less effective with others, indicating its potential for recycling and valorizing post-consumer plastic waste.
View Article and Find Full Text PDF

Bio-oil Fractionation According to Polarity and Molecular Size: Characterization and Application as Antioxidants.

Energy Fuels

October 2024

Aragon Institute for Engineering Research (I3A), Thermochemical Processes Group (GPT), University of Zaragoza, 50018 Zaragoza, Spain.

Bio-oil obtained from biomass pyrolysis has great potential for several applications after being upgraded and refined. This study established a method for separating bio-oil into different fractions based on polarity and molecular size to extract phenolic and polyphenolic compounds with antioxidant properties. The fractions were analyzed using various spectroscopic and chromatographic techniques, such as GC/MS, FTIR, UV-vis, SEC, DOSY-NMR, C-NMR, and P-NMR.

View Article and Find Full Text PDF

Bio-oils contain a substantial number of highly oxygenated hydrocarbons, which often exhibit low thermal stability during storage, handling, and refining. The primary objectives of this study are to characterize the hydroxyl group in bio-oil fractions and to investigate the relationship between the type of hydroxyl group and accelerated aging behavior. A bio-oil was fractionated into five solubility-based fractions, classified in two main groups: water-soluble and water-insoluble fractions.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!