Precipitation of gypsum is studied in a HARDTAC (High-Aspect Ratio, Draft-Tube, Agitated Crystallizer) reactor, which is considered as the core crystallization unit of lots of wastewater treatment systems. Coupling Computational Fluid Dynamics (CFD) and population balance modelling to simulate precipitation can be a useful tool to come to a decision about upstream and downstream units. In the present study, we aim to validate such approach by investigating gypsum precipitation in a HARDTAC pilot unit and comparing experiments results with simulation. Measured nucleation and growth kinetics are used to feed the model. A comparison between experiments and simulations is presented in the case of gypsum precipitation with a given set of operating conditions. Good agreement is obtained for species concentrations, gypsum mass fraction and volumetric mean diameter but some discrepancies still remain between measured and simulated crystal size distribution.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.2166/wst.2007.772 | DOI Listing |
J Environ Sci (China)
July 2025
Key Laboratory of Pollution Ecology and Environmental Engineering, Institute of Applied Ecology, Chinese Academy of Sciences, Shenyang 110016, China.
Siderite tailings is a potentially cost-free iron (Fe) source for arsenic (As) fixation in hazardous arsenic-calcium residues (ACR) as stable scorodite. In this study, a pure siderite reagent was employed to investigate the mechanism and optimal conditions for As fixation in ACR via scorodite formation, while the waste siderite tailings were used to further demonstrate the cotreatment method. The cotreatment method starts with an introduction of sulfuric acid to the ACR for As extraction and gypsum precipitation, and is followed by the addition of HO to oxidize As(III) in the extraction solutions and finalized by adding siderite with continuous air injection for scorodite formation.
View Article and Find Full Text PDFEnviron Sci Pollut Res Int
January 2025
Earth Sciences, Engineering Faculty, Autonomous University of San Luis Potosi, Av. Manuel Nava 8, San Luis Potosí, SLP, Mexico.
Ecosystems such as wetlands have karst groundwater as their primary source of preserving their services and functions. Karst systems are complex hydrogeological systems that are difficult to study because of their complicated functioning mechanism, which requires an interdisciplinary effort based on hydrodynamic assessment and characterization of the hydrogeology of the system. The study area is the Ramsar wetland Ciénaga de Tamasopo (Mexico), which is dependent on the discharge of karst groundwater that is affected by water extraction of extensive sugarcane agriculture and is also the main water source for the rural towns.
View Article and Find Full Text PDFACS Omega
January 2025
School of Materials and Metallurgy, Northeastern University, Shenyang, Liaoning 110004, China.
In the process of zinc hydrometallurgy, the content of fluorine in zinc sulfate solution directly affects the stripping of the zinc plate, which easily leads to the deterioration of working conditions. It not only has a serious impact on the entire zinc hydrometallurgical system but also causes huge economic losses. Especially in the process of zinc secondary resource utilization, the concentration of fluoride ions in the electrolyte exceeds the control standard of smelting enterprises, which has become a long-term technical challenge in the smelting industry.
View Article and Find Full Text PDFEnviron Pollut
January 2025
Department of Geology, Aligarh Muslim University, Aligarh, India.
Evolution of groundwater genesis in Central Ganga Plain (CGP) is scrutinized with due consideration of hydrochemical and hydrodynamic environment within Quaternary alluviums. Wide variation in hydrochemical facies in CGP indicates a dynamic hydro-geochemical environment influenced from the seasonal rainfall, return flows, canal seepages, and anthropogenic activities. The Ca-HCO facies retaining meteoric nature is characterized by shallow water levels, high recharge rate, high hydraulic conductivity, low salinity and trace elemental load.
View Article and Find Full Text PDFRSC Adv
January 2025
TECNALIA, Basque Research and Technology Alliance (BRTA), Parque Tecnológico de San Sebastián Mikeletegi Pasealekua 2 20009 Donostia-San Sebastián Spain +34 944 041 445 +34 946 430 850.
A downstream process for the recovery and purification of acetic acid (AA) from an extremely diluted solution (100 mg L) also containing a mixture of contaminating inorganic salts in the form of bicarbonates, phosphates, sulfates and chlorides (DPM medium) has been developed, showing its technical feasibility. The process involves two successive steps based on the use of a mixed bed ion exchange (IEX) resin. The first step, a demineralization treatment to remove the inorganic anions that could potentially interfere with the recovery and purification of AA, involves a combined treatment of calcium precipitation, acidification with the Amberlite IR-120 resin and treatment with the Amberlite MB20 mixed bed resin.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!