[Condylar positioning during clenching related to loss of posterior occlusal support].

Nihon Hotetsu Shika Gakkai Zasshi

Department of Oral and Maxillofacial Biology, Graduate School of Oral Medicine, Matsumoto Dental University, Japan.

Published: October 2007

Purpose: In the last two decades, the Shortened Dental Arch (SDA) concept has been introduced as a treatment strategy for posterior edentulous patients. This study investigated whether the SDA concept applies to all posterior edentulous patients.

Study Selection & Results: In the first study, objective evaluations for the temporomandibular joint (radiographic evaluation and measurement of condylar positioning during maximal voluntary contraction) were performed in patients with unilaterally posterior missing teeth. Abnormal condylar appearances were observed in 73% of subjects by radiographic evaluation and these phenomena coincided with edentulous-side in 55% of them. Condylar positioning during clenching was significantly larger on the edentulous-side compared to that in the dentulous-side. In the second study, we investigated the mandibular positioning during maximal voluntary contraction related to simulated loss of posterior occlusal supports in volunteers with natural dentitions. A greater bilateral loss of posterior occlusal support was associated with increased distances of positioning of both condyles. Moreover, subjects could be divided into two groups depending on the condylar mobility following reduced occlusal support. In the first group, the distance of condylar positioning significantly increased by cutting the splint sequentially from the posterior toward the anterior side. On the other hand, in the second group, no significant difference was observed between the distances measured under all the experimental occlusal conditions. In the supplemental study, a significant negative correlation was observed between the sagittal condylar guide inclination and the distance of ipsilateral condylar positioning. This result suggests that the steepness of the articular eminence is an important factor in condylar positioning during clenching.

Conclusion: We propose that clinical guidelines should be developed for determining whether to adopt a "Wait and See" approach for SDA patients without any proactive treatment, or to start prosthetic intervention immediately.

Download full-text PDF

Source
http://dx.doi.org/10.2186/jjps.51.699DOI Listing

Publication Analysis

Top Keywords

condylar positioning
20
loss posterior
12
posterior occlusal
12
positioning clenching
8
sda concept
8
posterior edentulous
8
study investigated
8
radiographic evaluation
8
condylar
8
positioning maximal
8

Similar Publications

Can robotic arm-assisted total knee arthroplasty be applied to valgus deformity.

Arch Orthop Trauma Surg

January 2025

Department of Orthopaedic Surgery, University Hospital centre (Saint Etienne), Avenue Albert Raimond, Saint-priest-en-Jarez, 42270, France.

Introduction: Total knee arthroplasty (TKA) in valgus knees is challenging. Optimal ligament balance, implant neutral or moderate valgus alignment are crucial but conventional instrumentations usually lead to outliers. Robotic arm assisted TKA (RATKA) advantages could answer this challenge.

View Article and Find Full Text PDF

Objectives: The objective of this study is to measuring the morphology and position of bilateral temporomandibular joints in patients with unilateral and bilateral molar scissor bite and simulating the deformation of the mandible during occlusion, in order to provide thesis for the diagnosis of temporomandibular joint disease in patients with unilateral and bilateral molar scissor bite.

Methods: This study was a retrospective study. A total of 10 patients with unilateral molar scissor bite (the unilateral molar scissor bite group) and 10 patients with bilateral molar scissor bite (the bilateral molar scissor bite group) were selected as the experimental group, and 20 adult patients with classⅠ of angle classification of similar ages were selected as the control group.

View Article and Find Full Text PDF

Objective: This study aimed to evaluate the positional and morphological changes in the temporomandibular joint (TMJ) in adult patients with skeletal Class I malocclusion treated with fixed orthodontic appliances (FAs) and clear aligners (CAs), both with and without premolar extractions.

Methods: This retrospective study involved 120 adult patients divided into non-extraction and extraction groups, each further subdivided equally into those treated with FAs and CAs. Cone beam computed tomography (CBCT) was used to assess the TMJ measurements before (T0) and after treatment (T1).

View Article and Find Full Text PDF

Background: This study aims to automate the measurement process of posterior condylar offset ratio (PCOR) and anterior condylar offset ratio (ACOR) to improve the Total Knee Arthroplasty (TKA) evaluation. Accurate calculation of PCOR and ACOR, performed manually by orthopedic surgeons, is crucial for assessing postoperative range of motion and implant positioning. Manual measurements, however, are time-consuming, prone to human error, and subject to variability.

View Article and Find Full Text PDF

Objectives: To assess the effect of patient positioning and general anesthesia on the condylar position in orthognathic surgery.

Materials And Methods: This prospective study included patients undergoing orthognathic surgery between 2019 and 2020. Four weeks prior to surgery (T0) cone-beam computed tomography (CBCT) scans and intra-oral scans (IOS) were acquired in an upright position.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!