Photochemical and discharge-driven pathways to aromatic products from 1,3-butadiene.

A detailed study of the photochemical and discharge-driven pathways taken by gas-phase 1,3-butadiene has been carried out. Photolysis or discharge excitation was initiated inside a short reaction tube attached to the outlet of a pulsed valve. Bath gas temperatures near 100 K were achieved in the reaction tube by the constrained expansion of the gas mixture into the tube, simulating temperatures of relevance in Titan's atmosphere. Photolysis of 1,3-butadiene was initiated at 218 nm with a laser pulse that counter-propagated the reaction tube. Discharge excitation was carried out using discharge electrodes imbedded in the reaction tube walls, enabling the study of the photochemical and discharge products under similar conditions. Products were detected using either single-photon VUV photoionization (118 nm = 10.5 eV) or resonant two-photon ionization (R(2)PI) spectroscopy in a time-of-flight mass spectrometer. Emphasis was placed on characterization of the aromatic products formed, since these may be of particular relevance to Titan's atmosphere, where benzene has been positively identified and 1,3-butadiene is projected as the principle pathway to its formation. Consistent with previous studies of the photodissociation of 1,3-butadiene, C(3)H(3) + CH(3) is the dominant primary product formed. Under the temperature-pressure conditions present in the reaction tube (T approximately 75-100 K, P = 50 mbar), C(6)H(6) is the dominant secondary photochemical product formed. A 1:1 C(4)H(6):C(4)D(6) mixture was used to prove that the C(6)H(6) product was formed by recombination of two C(3)H(3) radicals; however, a careful search for benzene revealed none, indicating that less than 1% of the C(6)H(6) formed in the reaction tube is benzene. This is consistent with expectations for these temperatures and pressures based on previous modeling of propargyl recombination. Two aromatic products were observed from the photochemistry: ethylbenzene and 3-phenylpropyne. Plausible pathways leading to these products are proposed. In the discharge, C(3)H(3) + CH(3) are also identified as significant primary neutral products and C(6)H(6) as a dominant higher-mass product. In this case, the C(6)H(6) was identified as benzene via its R2PI spectrum, appearing with intensity about 10 times larger than any other aromatic formed in the discharge. R2PI spectra of a total of about 15 aromatic products were recorded from the 1,3-butadiene discharge, among them toluene; styrene; phenylacetylene; o-, m-, and p-xylene; ethylbenzene; indane; indene; beta-methylstyrene; and naphthalene. Previously unidentified spectra in the m/z 142 and 144 mass channels were positively identified as the 1,3- and 1,4-isomers of phenylcyclopentadiene and the analogous 1-phenylcyclopentene.