[NOx storage and decomposition behavior of Cu-Mg-Al catalyst].

Huan Jing Ke Xue

Department of Environmental Science and Engineering, Tsinghua University, Beijing 100084, China.

Published: May 2007

Cu-Mg-Al hydrotalcite mixed oxide was prepared by co-precipitation. The mixed oxide and its procurer were characterized by XRD. NO, storage performance and decomposition of the stored NO, over the catalyst were investigated by NO, storage experiment at constant temperature, temperature programmed desorption (TPD) and temperature programmed surface reaction (TPSR), respectively. The results indicate that Cu-Mg-Al hydrotalcite mixed oxide has a good performance of NO, storage. The formed nitrate can be decomposed to gaseous NOx rapidly in the investigated temperature range of 160-360 degrees C, and a small amount of gaseous NO, can be reduced by C3 H6 with increasing the concentration of C3 H6 in the inlet gas.

Download full-text PDF

Source

Publication Analysis

Top Keywords

mixed oxide
12
cu-mg-al hydrotalcite
8
hydrotalcite mixed
8
temperature programmed
8
[nox storage
4
storage decomposition
4
decomposition behavior
4
behavior cu-mg-al
4
cu-mg-al catalyst]
4
catalyst] cu-mg-al
4

Similar Publications

Polysorbates degrading enzymes in biotherapeutics - a current status and future perspectives.

Front Bioeng Biotechnol

January 2025

Pharmaceutical Development Biologicals, TIP, Boehringer Ingelheim Pharma GmbH & Co., KG, Innovation Unit, Biberach an der Riss, Germany.

Polysorbates, in particular polysorbate (PS) 20 and 80, are the most commonly used surfactants for stabilising biotherapeutics produced by biotechnological processes. PSs are derived from ethoxylated sorbitan (a derivative of sorbitol) esterified with fatty acids of varying chain length and degree of saturation. In the past, these surfactants have been reported to have specific liabilities.

View Article and Find Full Text PDF

Near-Field Mixing in a Coaxial Dual Swirled Injector.

Flow Turbul Combust

November 2024

Institut de Mécanique des Fluides de Toulouse, IMFT, CNRS, Université de Toulouse, Toulouse, France.

Improving mixing between two coaxial swirled jets is a subject of interest for the development of next generations of fuel injectors. This is particularly crucial for hydrogen injectors, where the separate introduction of fuel and oxidizer is preferred to mitigate the risk of flashback. Raman scattering is used to measure the mean compositions and to examine how mixing between fuel and air streams evolves along the axial direction in the near-field of the injector outlet.

View Article and Find Full Text PDF

Many approaches have been implemented in order to reduce the emissions of particular pollutants without compromising engine performance. Cotton and castor mixed seed oil was chosen for the current study due to their distinct fatty acid composition and potential as a feedstock for bio-additives. Three fuel samples-99 % diesel and 1 % blended fuel (cottonseed oil + castor seed oil), 99.

View Article and Find Full Text PDF

In this study, magnesium-doped lithium manganese oxide nanoparticles were prepared through a solid-state reaction technique, and their surface was modified with mesoporous silica. The surface-modified material exhibited a significantly enhanced BET surface area from 5.791 to 66.

View Article and Find Full Text PDF

Cleaning-in-place (CIP) is the most commonly used cleaning and sanitation procedure for removing fouling deposits. Traditional CIP includes a series of chemical cleaning cycles, including alkaline, acid, and sanitizer. However, these chemicals are hazardous to the environment and employees.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!