Effect of iron on acid demineralisation of bovine enamel blocks by a soft drink.

Arch Oral Biol

Social Dentistry Department, Bauru School of Dentistry, University of São Paulo, Bauru, Al. Octávio Pinheiro Brisolla, 9-75 Bauru, SP 17012-901, Brazil.

Published: November 2007

Objectives: The aim of this study was to evaluate, in vitro, the effect of iron on the acid demineralisation of bovine enamel blocks by a soft drink.

Design: Twenty-four blocks of bovine enamel were randomly assigned to two groups (experimental and control), which were exposed to 4 cycles of demineralisation in Coke containing or not 10 mmol/L of iron, respectively, and another 4 cycles of remineralisation in artificial saliva. The softening of enamel was evaluated by % superficial microhardness change (SMHC) and wear analysis. Data were analysed using t-test (p<0.05).

Results: With regard to %SMHC, the experimental group presented average values (+/-S.E.) of -85.3+/-0.9, that were significantly higher (t=4.7, p<0.01) than the ones observed for control group (-76.7+/-1.6). The experimental group presented a mean wear (+/-S.E.) of 2.3+/-0.2 microm, that was significantly lesser (t=3.7, p<0.01) than the one observed for the control group (3.5+/-0.2 microm).

Conclusions: According to this protocol, iron at 10 mmol/L significantly reduced the wear, but significantly enhanced the %SMHC of enamel blocks submitted to erosion by Coke.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.archoralbio.2007.04.012DOI Listing

Publication Analysis

Top Keywords

bovine enamel
12
iron acid
8
acid demineralisation
8
demineralisation bovine
8
enamel blocks
8
blocks soft
8
enamel
4
soft drink
4
drink objectives
4
objectives aim
4

Similar Publications

Purpose: To compare the color alteration, surface roughness and microhardness and cross-sectional microhardness of bovine enamel treated with at-home whitening strips and gels.

Materials And Methods: Sixty-six pigmented specimens (n = 11) were allocated to six groups: C-cotton wool moistened with distilled water for 1 h; SDS-sodium dithionite strip, for 1 h; HPS-6.5% hydrogen peroxide strip, for 1 h; CPS-20% carbamide peroxide strip, for 1 h; HPG-7.

View Article and Find Full Text PDF

Acid resistance and bond strength of calcium-containing adhesive on ename.

Int Dent J

January 2025

Department of Cariology and Operative Dentistry, Graduate School of Medical and Dental Sciences, Institute of Science Tokyo, Bunkyo-ku, Tokyo, Japan.

Introduction And Aims: Marginal sealing by enamel bonding is important to enhance the durability of the restoration and prevent secondary caries after operative procedure. This study aimed to evaluate the enamel acid resistance and bond strength of an experimental calcium-containing adhesive system.

Methods: All materials were provided by Kuraray Noritake Dental, Inc.

View Article and Find Full Text PDF

This study aimed to evaluate the effectiveness of bioactive toothpastes in remineralizing eroded enamel surfaces in vitro. Bovine enamel blocks (n = 48) were obtained and classified into untreated, demineralized, and treated areas. Specimens were randomly classified into six groups (n = 8 each): fluoride-free toothpaste (NCT), Colgate Total 12 (PCT), Sensodyne Repair and Protect (SRP), Sensodyne Pronamel (SPE), Regenerador + Sensitive (RGS), and RGS/calcium booster (RCB).

View Article and Find Full Text PDF

Resin infiltration of trauma-induced enamel cracks - a proof-of-concept.

J Dent

December 2024

Department of Conservative Dentistry and Periodontology and Center of Dental Traumatology, University Hospital of Würzburg, Pleicherwall 2, 97070 Würzburg, Germany. Electronic address:

Objectives: The aim of this in-vitro study was to investigate the masking efficacy of adhesively sealed enamel cracks with resin infiltration compared with the use of a universal adhesive.

Methods: Enamel cracks were induced on the labial surfaces of bovine teeth using a pendulum impact tester. Specimens were treated adhesively by resin infiltration with ICON (DMG) or Scotchbond Universal Plus (3M).

View Article and Find Full Text PDF

Objectives: This in vitro study aimed to investigate the toothbrushing wear on both enamel and dentin surfaces of reference and commercially available dentifrices.

Methods: Bovine enamel and dentin blocks were initially polished and embedded within a resin composite in square shapes (10×8×6 mm3). Employing toothbrushes equipped with nylon bristles, a toothbrushing machine was utilized, subjecting dentin specimens (n = 36) to 500 brush cycles and enamel samples to 5000 brush cycles (n = 36).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!