A feasibility test of a 17 m3-pilot-scale sewage treatment system was carried out by continuous feeding of raw municipal sewage under ambient temperature conditions. The system consisted of a UASB and an aerated fixed bed reactor. Some of the effluent from the fixed bed reactor was returned to the UASB influent in order to provide a sulfate source. The total BOD of 148-162 mg l(-1) in the influent was reduced to a more desirable 11-25 mg l(-1) in the final effluent. The levels of methane-producing activity from acetate and H2/CO2 gas at 10 degrees C were only 2% and 0% of those at 35 degrees C, respectively. On the other hand, the sulfate-reducing activity levels of the UASB sludge were relatively high at 10 degrees C, for example, 18% for acetate and 9% for H2/CO2 gas, compared to the activity levels at 35 degrees C. Therefore, BOD oxidization by sulfate reduction in the UASB was greater than that by methane production under low temperature conditions. This sulfate-reducing activity tended to be proportional to the copy number of adenosine-5'-phosphosulfate (APS) reductase genes in DNA extracted from the sludge.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.biortech.2005.10.020DOI Listing

Publication Analysis

Top Keywords

fixed bed
12
sewage treatment
8
treatment system
8
uasb aerated
8
aerated fixed
8
ambient temperature
8
temperature conditions
8
bed reactor
8
acetate h2/co2
8
h2/co2 gas
8

Similar Publications

Optimizing low-temperature CO oxidation under realistic combustion conditions: The impact of CeO morphology on Au/CeO catalysts.

J Hazard Mater

January 2025

State Key Laboratory of Fire Science, University of Science and Technology of China, Hefei 230026, PR China; Suzhou Key Laboratory for Urban Public Safety, Suzhou Institute for Advanced Research, University of Science and Technology of China, Suzhou, Jiangsu 215123, PR China. Electronic address:

The development of carbon monoxide oxidation catalysts for complex gas environments faces significant challenges in fire scenarios. Only a few representative gases are used as interfering components in simulated real smoke under laboratory conditions, which cannot accurately reflect the performance of catalysts in a real fire. Herein, Au/CeO catalysts with high activity were prepared by adjusting the morphology (rod, cube, polyhedron and irregular particles) and exposed crystal surface ratio of CeO.

View Article and Find Full Text PDF

Efficient continuous SF/N separation using low-cost and robust metal-organic frameworks composites.

Nat Commun

January 2025

Key Laboratory of Biomass Chemical Engineering of Ministry of Education, College of Chemical and Biological Engineering, Zhejiang University, Hangzhou, Zhejiang, China.

Physisorption presents a promising alternative to cryogenic distillation for capturing the most potent greenhouse gas, SF, but existing adsorbents face challenges in meeting diverse chemical and engineering concerns. Herein, with insights into in-pore chemistry and industrial process design, we report a systematic investigation that constructed two low-cost composites pellets (Al(fum)@2%HPC and Al(fum)@5%Kaolin) coupled with an innovative two-stage Vacuum Temperature Swing Adsorption (VTSA) process for the ultra-efficient recovery of low-concentration SF from N. Record-high selectivities (> 2×10) and SF dynamic capacities (~ 2.

View Article and Find Full Text PDF

Advanced adiabatic compressed air energy storage systems dynamic modelling: Impact of the heat storage device.

Heliyon

January 2025

IFP Energies nouvelles, 1 et 4 avenue de Bois Préau, 92852, Rueil-Malmaison, France.

Advanced Adiabatic Compressed Air Energy Storage (AACAES) is a technology for storing energy in thermomechanical form. This technology involves several equipment such as compressors, turbines, heat storage capacities, air coolers, caverns, etc. During charging or discharging, the heat storage and especially the cavern will induce transient behavior of operating points, notably temperature, pressure, and volume flow.

View Article and Find Full Text PDF

Effects of relative microplastic-biochar sizes and biofilm formation on fragmental microplastic retention in biochar filters.

Environ Res

January 2025

Department of Environmental and Sustainable Engineering, Faculty of Engineering, Chulalongkorn University, 254 Phayathai Road, Pathumwan, Bangkok, 10330, Thailand; Professor Aroon Sorathesn Center of Excellence in Environmental Engineering, Department of Environmental and Sustainable Engineering, Faculty of Engineering, Chulalongkorn University, Bangkok, 10330, Thailand.

Microplastics (MPs) pose significant risks to aquatic life and human health. Conventional water treatment is ineffective in removing MPs, demanding alternative technologies. Biochar exhibits a potential for removing MPs through adsorption and filtration.

View Article and Find Full Text PDF

This study demonstrated a novel approach to accurately estimate 5-day biochemical oxygen demand (BOD) in textile wastewater using a microbial consortium from food processing wastewater fixed on coconut fibers. Although glucose-glutamic acid (GGA) has been widely known as the most preferred substrates for microbial respiration, its calibration surprisingly resulted in an overestimation of BOD in textile wastewater due to its lower utilization rate compared to that of textile wastewater. After being adapted with a new nutrient environment composed of GGA and textile wastewater, the adapted packed-bed bioreactors (PBBRs) was capable of accurate estimation of BOD in textile wastewater using GGA standard solution.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!