Spatiotemporal profile of dendritic outgrowth from newly born granule cells in the adult rat dentate gyrus.

Brain Res

Department of Anatomy and Neurobiology, School of Medicine, University of California, Irvine, CA 92697-1275, USA.

Published: May 2007

Neurogenesis in the adult dentate gyrus occurs in the subgranular zone where newborn neurons (NNs) migrate a short distance into the granule cell layer and extend their rudimentary apical dendritic processes upon a radial glial scaffold. Using doublecortin (DCX) immunocytochemistry, these growing dendrites can be visualized because dendritic growth cones, including filipodia and lamellipodia, are labeled in both light and electron microscopic preparations. To study the rate of dendritic outgrowth of newborn dentate granule cells, single injections of 5-bromo-2-deoxyuridine (BrdU) with different survival times were combined with double immunolabeling for BrdU and DCX. At the earliest time points (4 and 12 h after BrdU injections), a rudimentary process can be observed to emanate from BrdU/DCX double-labeled cells. By 48 h the dendrites first appeared in the molecular layer. By 96 h after BrdU injection, these apical dendrites extended into the middle of the molecular layer where they ramified. The calculated rate of dendritic growth for NNs was about 15 microm per day for the first 3 days, and then a doubling in length occurred at 4 and 5 days that coincided with a retraction of the basal dendrite. In addition, electron microscopy of DCX-labeled apical dendrites showed that they were much thinner (1/4 to 1/3 the size) in diameter than unlabeled, mature apical dendrites and that they had developing synapses on them in the molecular layer.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.brainres.2006.07.032DOI Listing

Publication Analysis

Top Keywords

molecular layer
12
apical dendrites
12
dendritic outgrowth
8
granule cells
8
dentate gyrus
8
dendritic growth
8
rate dendritic
8
dendritic
5
dendrites
5
spatiotemporal profile
4

Similar Publications

The deformation behavior and instabilities occurring during the drawing of high-density polyethylene (HDPE) were investigated using wide- and small-angle X-ray scattering (WAXS and SAXS) and scanning electron microscopy (SEM) in plain HDPE and paraffin wax- and/or chloroform-modified samples. In contrast to neat HDPE, the modified materials demonstrated strongly suppressed cavitation. However, regardless of cavitation, the tensile deformation of all samples was found to be governed by crystallographic mechanisms active in the crystalline lamellae, supported by shear in the amorphous layers, i.

View Article and Find Full Text PDF

Polyurethane (PU) grouting materials are widely used in underground engineering rehabilitation, particularly in reinforcement and waterproofing engineering in deep-water environments. The long-term effect of complex underground environments can lead to nanochannel formation within PU, weakening its repair remediation effect. However, the permeation behavior and microscopic mechanisms of water molecules within PU nanochannels remain unclear.

View Article and Find Full Text PDF

infections continue to pose a significant global health challenge, particularly due to the rise of multidrug-resistant strains, random mycobacterial mutations, and the complications associated with short-term antibiotic regimens. Currently, five approved drugs target cell wall biosynthesis in . This review provides a comprehensive analysis of these drugs and their molecular mechanisms.

View Article and Find Full Text PDF

To provide insight into the interface structure in Ti particle-reinforced Mg matrix composites, this study investigates the inherent Mg/Ti interface structure formed during the solidification of supercooled Mg melt on a (0001)Ti substrate using ab initio molecular dynamics (AIMD) simulations and density function theory (DFT) calculation. The resulting interface exhibits an orientation relationship of 0001Mg//0001Ti with a lattice mismatch of approximately 8%. Detailed characterizations reveal the occurrences of 0001Mg plane rotation and vacancy formation to overcome the lattice mismatch at the inherent Mg/Ti interface while allowing Mg atoms to occupy the energetically favorable hollow sites above the Ti atomic layer.

View Article and Find Full Text PDF

Optimization of In-Situ Growth of Superconducting Al/InAs Hybrid Systems on GaAs for the Development of Quantum Electronic Circuits.

Materials (Basel)

January 2025

CNR-IOM-Istituto Officina dei Materiali, Consiglio Nazionale delle Ricerche, 34149 Trieste, Italy.

Hybrid systems consisting of highly transparent channels of low-dimensional semiconductors between superconducting elements allow the formation of quantum electronic circuits. Therefore, they are among the novel material platforms that could pave the way for scalable quantum computation. To this aim, InAs two-dimensional electron gases are among the ideal semiconductor systems due to their vanishing Schottky barrier; however, their exploitation is limited by the unavailability of commercial lattice-matched substrates.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!