3-D microwell culture of human embryonic stem cells.

Biomaterials

Department of Chemical and Biological Engineering, University of Wisconsin-Madison, 1415 Engineering Drive, Madison, WI 53706, USA.

Published: December 2006

Human embryonic stem cells (hESCs) have the ability to proliferate indefinitely and differentiate into each of the embryonic cell lineages. Great care is required to maintain undifferentiated hESC cultures since spontaneous differentiation often occurs in culture, presumably resulting from soluble factors, cell-cell contact, and/or cell-matrix signaling. hESC differentiation is typically stimulated via generation of embryoid bodies (EBs) and lineage commitment of individual cells depends upon numerous cues throughout the EB environment, including EB shape and size. Common EB formation protocols, however, produce a very heterogeneous size distribution, perhaps reducing efficiency of directed differentiation. We have developed a 3-D microwell-based method to maintain undifferentiated hESC cultures for weeks without passaging using physical and extracellular matrix patterning constraints to limit colony growth. Over 90% of hESCs cultured in microwells for 2-3 weeks were viable and expressed the hESC transcription marker Oct-4. Upon passaging to Matrigel-coated tissue culture-treated polystyrene dishes (TCPS), microwell cultured hESCs maintained undifferentiated proliferation. Microwell culture also permits formation of hESC colonies with a defined size, which can then be used to form monodisperse EBs. When cultured in this system, hESCs retained pluripotency and self-renewal, and were able to be passaged to standard unconstrained culture conditions.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.biomaterials.2006.07.012DOI Listing

Publication Analysis

Top Keywords

microwell culture
8
human embryonic
8
embryonic stem
8
stem cells
8
maintain undifferentiated
8
undifferentiated hesc
8
hesc cultures
8
hesc
5
3-d microwell
4
culture
4

Similar Publications

Mechanobiology of 3D cell confinement and extracellular crowding.

Biophys Rev

December 2024

Macromolecular Engineering Laboratory, Department of Mechanical and Process Engineering, ETH Zurich, 8092 Zurich, Switzerland.

Cells and tissues are often under some level of confinement, imposed by the microenvironment and neighboring cells, meaning that there are limitations to cell size, volume changes, and fluid exchanges. 3D cell culture, increasingly used for both single cells and organoids, inherently impose levels of confinement absent in 2D systems. It is thus key to understand how different levels of confinement influences cell survival, cell function, and cell fate.

View Article and Find Full Text PDF

A thermoplastic chip for 2D and 3D correlative assays combining screening and high-resolution imaging of immune cell responses.

Cell Rep Methods

January 2025

Department of Applied Physics, Science for Life Laboratory, KTH Royal Institute of Technology, Stockholm, Sweden; Department of Medicine, Center for Infectious Medicine, Huddinge, Karolinska Institutet, Stockholm, Sweden. Electronic address:

We present an easy-to-use, disposable, thermoplastic microwell chip designed to support screening and high-resolution imaging of single-cell behavior in two- and three-dimensional (2D and 3D) cell cultures. We show that the chip has excellent optical properties and provide simple protocols for efficient long-term cell culture of suspension and adherent cells, the latter grown either as monolayers or as hundreds of single, uniformly sized spheroids. We then demonstrate the applicability of the system for single-cell analysis by correlating the dynamic cytotoxic response of single immune cells grown under different metabolic conditions to their intracellular cytolytic load at the end of the assay.

View Article and Find Full Text PDF

pH remains the most important chemical parameter and must be monitored for positive outcomes in areas as different as cheese making and fertilisation (IVF). Where blood gas analysers enable patient monitoring, starter cultures in cheese manufacturing are still monitored using conventional pH electrodes. Here, we present a homogeneous multiwell plate sensor for monitoring pH, with the same sensitivity as a pH electrode.

View Article and Find Full Text PDF

Concave Microwell Formation Induced by PDMS Water Vapor Permeability for Spheroid Generation.

Micromachines (Basel)

December 2024

Institute of Life Science and Resources & Department of Food Science and Biotechnology, College of Life Sciences, Kyung Hee University, Yongin 17104, Republic of Korea.

This study introduces a novel method for the fabrication of concave microwells involving water vapor permeation through polydimethylsiloxane (PDMS). This method leverages the exceptional water vapor permeability of PDMS to enable a scalable and cost-effective fabrication process, addressing the limitations of existing techniques such as photolithography that are resource-intensive and complex. PDMS is more permeable to water vapor than to other gas molecules, resulting in the formation of microwells.

View Article and Find Full Text PDF

: Vascular endothelial growth factor (VEGF) is a protein which stimulates the formation of new blood vessels, playing a crucial role in processes such as wound healing and tumor growth. : This study investigated the effects of VEGF on cell viability and osteogenic differentiation in mesenchymal stem cell (MSC) spheroids. Stem cell spheroids were fabricated using concave microwells and cultured with VEGF at concentrations of 0, 0.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!