Nonadiabatic molecular dynamics study of electron transfer from alizarin to the hydrated Ti4+ ion.

J Phys Chem B

Department of Chemistry, University of Washington, Seattle, Washington 98195-1700, USA.

Published: September 2005

Ab initio real-time nonadiabatic (NA) molecular dynamics (MD) simulations are performed in order to investigate the photoinduced electron transfer (ET) from alizarin to the hydrated Ti4+ ion and compare it with the ET into bulk TiO2 that forms the basis of the Grätzel type solar cell. The experimental data and electronic structure calculations indicate that the photoexcitation spectra of alizarin attached to either bulk TiO2 or the Ti4+ ion in solution are very similar. In contrast, the NAMD simulations at ambient temperature predict marked differences between the ET dynamics that follow the photoexcitation in the two systems. The simulation of ET between alizarin and the TiO2 surface shows predominantly adiabatic transfer that occurs within 8 fs (Duncan et al. J. Am. Chem. Soc. 2005, 127, 7941), in agreement with the time-resolved experimental data. The simulation of alizarin attached to the hydrated Ti4+ ion reported presently predicts that the ET does occur, but on a slower 30 fs time scale, with a substantially reduced amplitude and by a predominantly NA mechanism. The differences are attributed to the disparity in the acceptor states of bulk TiO2 and the Ti4+ ion in solution. It is shown that the predicted alizarin-Ti4+ ET dynamics can be verified experimentally.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jp052570xDOI Listing

Publication Analysis

Top Keywords

ti4+ ion
20
hydrated ti4+
12
bulk tio2
12
nonadiabatic molecular
8
molecular dynamics
8
electron transfer
8
transfer alizarin
8
alizarin hydrated
8
experimental data
8
alizarin attached
8

Similar Publications

Article Synopsis
  • All-solid-state lithium-ion batteries (ASSLBs) are poised to enhance the performance and safety of next-generation electronics, especially electric vehicles, by utilizing solid electrolytes with high ionic conductivity.
  • Researchers have substituted the B-site of LiLaTiO (LLTO) with Ga to create Ga-doped LLTO solid electrolytes, leading to structural improvements, enhanced ionic conductivity, and better electrochemical stability through a solid-state reaction method.
  • The results show that Ga-doped LLTO exhibits a significantly increased ionic conductivity of 4.15 × 10 S cm in LiLaTiGaO (with 3% Ga), making it a promising candidate for future ASSLB applications due to its stable operating voltage range.
View Article and Find Full Text PDF

High-entropy NASICON-Type LiAlTiZrSnTa(PO) with high electrochemical stability for lithium-ion batteries.

J Colloid Interface Sci

December 2024

Department of Materials Science and Engineering, National Tsing Hua University, Hsinchu 300044, Taiwan; High Entropy Materials Center, Hsinchu 300044, Taiwan. Electronic address:

LiAlTi (PO) (LATP) is a promising NASICON-type solid electrolyte for all-solid-state lithium-ion batteries (ASSLIBs) owing to its high ionic conductivity, low cost, and stability in ambient atmosphere. However, the electrochemical stability of LATP suffers upon contact with lithium metals, resulting in a reduction of Ti to Ti in its structure. This limitation necessitates interface modification processes, hindering its use in lithium-ion batteries.

View Article and Find Full Text PDF

Hybridization effects on the magnetic ground state of ruthenium in double perovskite LaZnRuTiO.

J Phys Condens Matter

January 2025

School of Materials Science, Indian Association for the Cultivation of Science, Calcutta 700 032, Kolkata, West Bengal, 700032, INDIA.

An exotic quantum mechanical ground state, i.e. the nonmagnetic= 0 state, has been predicted for higher transition metal tsystems, due to the influence of strong spin-orbit coupling (SOC) or in other words, due to unquenched orbital moment contribution.

View Article and Find Full Text PDF
Article Synopsis
  • This study highlights the critical role of light in facilitating exciton formation and separation in photocathodes, essential for charging lithium-ion batteries.
  • Light induces oxidation changes in titanium-based cathodes, while heat fails to produce similar effects.
  • The research suggests that effectively managing heat and light can lead to more efficient solar energy systems with minimal impact on battery components.
View Article and Find Full Text PDF

The P2-NaMnO cathode material has long been constrained by phase transitions induced by the Jahn-Teller (J-T) effect during charge-discharge cycles, leading to suboptimal electrochemical performance. In this study, we employed a liquid phase co-precipitation method to incorporate Ti during the precursor MnO synthesis, followed by calcination to obtain NaTiMnO materials. We investigated the effects of Ti doping on the structure, morphology, Mn concentration, and Na diffusion coefficients of NaTiMnO.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!