Unlabelled: The aim of this study was to investigate the effect of light intensity on polymerization shrinkage of resin composites. The five materials tested were Lite-Fil (A) (LFA), Lite-Fil (P) (LFP), Z100, Palfique, (PAL) and Tetric (TRC). Two types of measurements were made to determine the effects of environmental temperature and light intensity. Results were analyzed by two-way analysis of variance (ANOVA) and Newman-Keuls procedure at (P<0.05). The changes in temperature and/or light intensity strongly affected composite shrinkage. The amount of shrinkage for LFP at 100% light intensity in room temperature (23 degrees C) was 1.26% and increased up to 2.29% at 60 degrees C. By raising the temperature to 37 degrees C and dropping the light intensity to 42% (459 mW/cm2), the amount of polymerization shrinkage was similar to that with full light intensity, and statistically there were no significant differences between 37 degrees C, 45 degrees C, and 60 degrees C. Lower temperatures and lower light intensities produce lower values of shrinkage. However, if the light intensity is below 28%, higher temperatures (60 degrees C) must be applied to obtain a comparable amount of shrinkage.
Clinical Relevance: Pre-heating composite resin materials at body temperature (37 degrees C) is likely to improve physical properties and compensate any drop of light intensity.
Download full-text PDF |
Source |
|---|
Publication Analysis
Top Keywords
Similar Publications
Interaction of light with gas-liquid interfaces: influence on photon absorption in continuous-flow photoreactors.
React Chem Eng
January 2025
Flow Chemistry Group, van't Hoff Institute for Molecular Sciences (HIMS), Universiteit van Amsterdam (UvA) 1098 XH Amsterdam The Netherlands
Light interacts with gas bubbles in various ways, potentially leading to photon losses in gas-liquid photochemical applications. Given that light is a valuable 'reagent', understanding these losses is crucial for optimizing reactor efficiency. In this study, we address the challenge of quantifying these interactions by implementing a method that separately determines the photon flux and utilizes actinometric experiments to determine the effective optical path length, a key descriptor of photon absorption.
View Article and Find Full Text PDFLumbar total disk replacement versus microsurgical lumbar discectomy in treatment of radicular and back pain in railway workers: a prospective randomized controlled trial.
J Spine Surg
December 2024
Department of Neurosurgery, Asfendiyarov Kazakh National Medical University, Almaty, Kazakhstan.
Background: Currently, there remains a high percentage of complications after lumbar discectomy, while there is no uniform tactic to prevent their development. Purpose of the study was to compare the clinical efficacy and return to work rate (RWR) after total disk replacement (TDR) and microsurgical lumbar discectomy (MLD) in railway workers with lumbar disk herniation (LDH).
Methods: We randomly assigned 75 patients out of a total of 81 patients, between 25 and 35 years of age who had one level LDH to undergo single-level TDR surgery (group I, n=37) or MLD surgery (group II, n=38) in the L4-L5 or L5-S1 segments.
Engineering the Novel Extremophile Alga for High Lipid and High Starch Production as a Path to Developing Commercially Relevant Strains.
ACS ES T Eng
January 2025
Department of Molecular Biology, School of Biological Sciences, University of California San Diego, La Jolla, San Diego, California 92093, United States.
Microalgae offer a compelling platform for the production of commodity products, due to their superior photosynthetic efficiency, adaptability to nonarable lands and nonpotable water, and their capacity to produce a versatile array of bioproducts, including biofuels and biomaterials. However, the scalability of microalgae as a bioresource has been hindered by challenges such as costly biomass production related to vulnerability to pond crashes during large-scale cultivation. This study presents a pipeline for the genetic engineering and pilot-scale production of biodiesel and thermoplastic polyurethane precursors in the extremophile species .
View Article and Find Full Text PDFToxicity assessment and bioimaging potential of carbon dots synthesized from banana peel in zebrafish model.
Narra J
December 2024
Research Group of Pharmaceutics, School of Pharmacy, Institut Teknologi Bandung, Bandung, Indonesia.
Zebrafish serve as a pivotal model for bioimaging and toxicity assessments; however, the toxicity of banana peel-derived carbon dots in zebrafish has not been previously reported. The aim of this study was to assess the toxicity of carbon dots derived from banana peel in zebrafish, focusing on two types prepared through hydrothermal and pyrolysis methods. Banana peels were synthesized using hydrothermal and pyrolysis techniques and then compared for characteristics, bioimaging ability, and toxicity in zebrafish as an animal model.
View Article and Find Full Text PDFNear-infrared (NIR) phosphor-converted light-emitting diode (pc-LED) has emerged as the most promising NIR light source, highlighting the importance of exploring phosphors with excellent efficiency and sufficient spectral coverage. Herein, a garnet NaCaHfGeO:Cr phosphor with an internal quantum efficiency (IQE) of 79.2% has been developed, which exhibits a relatively long wavelength NIR emission peak at 830 nm and a full width at half maximum (FWHM) of 144 nm.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!