It has been claimed that implanted metals can cause backscatter radiation in radiation therapy with a dose enhancement at the bone-metal and tissue-metal interfaces on the beam entrance side. Theoretical calculations and experimental measurements with ionization chambers have indicated that such effects might be significant. Titanium implants are increasingly used in oral and maxillo-facial surgery for reconstruction purposes. A more detailed knowledge of backscatter-induced effects is therefore desired when head and neck cancers in patients with implants are treated with radiotherapy. We have made comparisons of cell survival after irradiation of two types of cultured cells grown directly on titanium metal and on plastic control supports. The cell cultures were irradiated with either 60Co photons or range modulated protons. No significant differences in the colony-forming capacity were found between the irradiated cells grown on titanium and those grown on plastic control supports. This was the case for both radiation types and the results were also observed to be dose-independent. The only observed phenomena were that the two cell-lines differed in radiosensitivity and that protons gave higher biological effects than gamma radiation. The results show that there were no significant changes in cell survival at the interface between the tissue equivalent medium and titanium support indicating that a dose increase induced by backscatter radiation, which possibly could demolish the osseointegration or induce osteoradionecrosis, are minimal when high energy photons or range modulated protons are applied.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.3109/02841869109091835 | DOI Listing |
Front Endocrinol (Lausanne)
December 2024
Department of Rheumatology and Clinical Immunology, Charité - Universitätsmedizin Berlin, Corporate Member of Freie Universität Berlin and Humboldt- Universität zu Berlin, Berlin, Germany.
Introduction: Diabetes mellitus (DM) is a chronic metabolic disorder that increases fragility fracture risk. Conventional DXA-based areal bone mineral density (aBMD) assessments often underestimate this risk. Cortical Backscatter (CortBS) ultrasound, a radiation-free technique, non-invasively analyzes cortical bone's viscoelastic and microstructural properties.
View Article and Find Full Text PDFSensors (Basel)
November 2024
Center for Frontier Medical Engineering, Chiba University, 1-33, Yayoicho, Inage-ku, Chiba 263-8522, Japan.
The objective of this work is to address the need for versatile and effective tissue characterization in abdominal ultrasound diagnosis using a simpler system. We evaluated the backscattering coefficient (BSC) of several tissue-mimicking phantoms utilizing three different ultrasonic probes: a single-element transducer, a linear array probe for clinical use, and a laboratory-made annular array probe. The single-element transducer, commonly used in developing fundamental BSC evaluation methods, served as a benchmark.
View Article and Find Full Text PDFThe X-ray lobster eye lens, an innovative technique for focusing high-energy radiation, enables wide-field X-ray imaging. However, its inherent cross point spread function introduces noise and degradation into the resultant images. Conventional image restoration methods are inadequate for suppressing such noise.
View Article and Find Full Text PDFRadiat Prot Dosimetry
November 2024
Nuclear and Ionizing Radiation Metrology Section, Office of Atoms for Peace, Bangkok 10900, Thailand.
Interventional radiology (IR) provides significant advancements in diagnostic and therapeutic procedures, yet concerns persist regarding radiological risks such as erythema, burns, and epilation. Direct dose measurements observed difficulties regarding the perturbation of the detector probe in X-ray images during fluoroscopy-guided procedures, high-cost expenses, and non-compliant patients. This study aims to develop a statistical-based model for estimating entrance skin dose (ESD) in body IR procedures using patient radiation-dose recording data.
View Article and Find Full Text PDFEx-situ Raman spectroscopy is a well-established method for the structural characterization of soot but necessitates a sampling step before analysis is made. This work studied the potential to perform Raman spectroscopic measurements of soot directly in the combustion exhaust gases, i.e.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!