Quantitation of toxic arsenic species and arsenobetaine in Pacific oysters using an off-line process with hydride generation-atomic absorption spectroscopy.

An off-line process-based speciation technique was devised here to quantitatively determine toxic inorganic arsenic (iAs), methylarsonic acid (MA), dimethylarsinic acid (DMA), and the dominant, albeit virtually nontoxic, arsenobetaine (AB) in Pacific oysters (Crassostrea gigas). Oysters were extracted with fresh methanol-water (8+2), and this was replicated three times. They were then evaporated to near dryness and subsequently redissolved in pure water; defatting was then performed with a C18 cartridge. The trace hydride active arsenic species, that is, iAs, MA, and DMA, in the defatted solutions were determined with a sensitive hydride generation-packed coldfinger trap-atomic absorption spectrometric (HG-PCFT-AAS) coupled system. The arsenicals that were desorbed from the cation-exchange resin (Dowex 50W-X8) in the washings of 4 M NH3 were categorized on the basis of AB + DMA. The total quantity of arsenic in the recovered AB + DMA was determined with a commercial hydride generation-atomic absorption spectrometric (HG-AAS) system, and finally, AB was calculated from (AB + DMA) - DMA. The average concentrations of iAs, MA, DMA, AB, and total arsenic (TAs) in the oysters collected from six aquacultural sites along the west coast of Taiwan were, respectively, 0.15, 0.06, 0.64, 6.93, and 13.74 mg kg(-1) of dry weight. AB was the major species, whereas iAs (arsenite + arsenate) were the most toxic species, although the iAs made up only approximately 1% of the TAs in the oysters. The lifetime target cancer risk, as determined by the concentration of iAs on a fresh weight basis in the oysters, was well below the ordinary health protection criteria (10(-6)).