Preparation and in vitro evaluation of mucoadhesive properties of alginate/chitosan microparticles containing prednisolone.

Int J Pharm

Department of Pharmaceutical Technology, Faculty of Pharmaceutical Sciences, Naresuan University, Phitsanulok 65000, Thailand.

Published: April 2006

This study describes the preparation of mucoadhesive alginate/chitosan microparticles containing prednisolone intended for colon-specific delivery. Two methods have been used for the preparation of the particles: the one-step method is the method in which prednisolone was dispersed within sodium alginate solution and this dispersion was then dropped in a solution containing both calcium chloride and chitosan. The two-step method consisted also of the dispersion of prednisolone in alginate solution and then dropping this dispersion into a solution containing calcium chloride, the particles were then transferred to a chitosan solution. The concentration of sodium alginate solution at 2% (w/v), various concentrations of calcium chloride solution (0.5-1.0%, w/v), chitosan solutions (0.5, 1.0 and 1.5%, w/v) and prednisolone drug load (2, 5, 10 and 15%, w/v) have been used. The results for both preparation methods show that the particle size and drug content were mainly depending on the amount of the drug concentration and not the amount of chitosan and calcium chloride. The in vitro mucoadhesive tests for particles prepared from both methods were carried out using the freshly excised gut of pigs. The particles prepared by the one-step method exhibited excellent mucoadhesive properties after 1h test. Increased chitosan concentrations from 0, 0.5, 1.0 to 1.5% (w/v) resulted in 43, 55, 82 and 88% of the particle remaining attached on the gut surface after 1 h, respectively. However, the particles prepared by the two-step method showed significant less mucoadhesion under the same experimental conditions. At chitosan concentrations of 0, 0.5, 1.0 and 1.5% (w/v) the amount of particles remaining attached to the mucosal surface of the pig gut after 1 h was 43, 3, 11 and 11%, respectively. The prednisolone release at a pH of 6.8 after 4 h was between 63 and 79% for the particles prepared by the one-step method and between 57 and 88% for the particles prepared by the two-step method with a prednisolone drug load of 5 and 10% (w/v), respectively. The results show that depending on the preparation method these chitosan coated alginate particles show different mucoadhesiveness whereas their other properties are not statistically significant different.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ijpharm.2006.01.003DOI Listing

Publication Analysis

Top Keywords

particles prepared
20
calcium chloride
16
15% w/v
16
one-step method
12
alginate solution
12
two-step method
12
particles
9
mucoadhesive properties
8
alginate/chitosan microparticles
8
microparticles prednisolone
8

Similar Publications

In this study, ultrasound-assisted glycated ovalbumin (G-UOVA) based on natural deep eutectic solvents (NADES) was prepared using response surface optimization. The binding affinity of (-)-gallocatechin gallate (GCG) to native OVA (NOVA), ultrasound treated OVA (UOVA), glycated OVA (GOVA), and G-UOVA followed G-UOVA > GOVA > UOVA > NOVA. The effects of various modifications and GCG binding on the secondary structure, particle size, and thermal stability of NOVA were investigated.

View Article and Find Full Text PDF

The viscoelastic properties of biological membranes are crucial in controlling cellular functions and are determined primarily by the lipids' composition and structure. This work studies these properties by varying the structure of the constituting lipids in order to influence their interaction with high-density lipoprotein (HDL) particles. Various fluorescence-based techniques were applied to study lipid domains, membrane order, and the overall lateral as well as the molecule-internal glycerol region mobility in HDL-membrane interactions (i.

View Article and Find Full Text PDF

Oxygenated VOC Detection Using SnO Nanoparticles with Uniformly Dispersed BiO.

Nanomaterials (Basel)

December 2024

Department of Advanced Materials Science and Engineering, Faculty of Engineering Sciences, Kyushu University, Kasuga 816-8580, Fukuoka, Japan.

BiO particles are introduced as foreign additives onto SnO nanoparticles (NPs) surfaces for the efficient detection of oxygenated volatile organic compounds (VOCs). BiO-loaded SnO materials are prepared via the impregnation method followed by calcination treatment. The abundant BiO/SnO interfaces are constructed by the uniform dispersion of BiO particles on the SnO surface.

View Article and Find Full Text PDF

In order to broaden the working voltage (1.23 V) of aqueous supercapacitors, a high-performance asymmetric supercapacitor with a working voltage window reaching up to 2.1 V is assembled using a nanorod-shaped molybdenum trioxide (MoO) negative electrode and an activated carbon (AC) positive electrode, as well as a sodium sulfate-ethylene glycol ((NaSO-EG) electrolyte.

View Article and Find Full Text PDF

Direct preparation of silver nanoclusters is of great significance for their applications. In this work, by selecting sodium cyanoborohydride as a weak reducing agent to control the kinetics of the reduction reaction, we successfully prepared silver nanoclusters protected by thiol-containing ligands, including mercaptosuccinic acid, cysteine, and glutathione. Based on the silver nanoclusters protected by mercaptosuccinic acid, silver-gold alloy nanoclusters were obtained through a gold doping reaction.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!