Homodyne detection is proposed to increase the readout signal of bit-oriented holographic memories. It can be easily implemented on present memory architectures by making the diffracted signal interfere with a reflection of the reading beam. The large resulting increase of the readout signal can be used to enhance the data transfer rate. A first experimental demonstration of such a readout procedure is presented.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/ol.31.000175 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Simulation of high signal-to-noise ratio resonant photodetector for homodyne measurement and its verification.
Rev Sci Instrum
January 2025
Key Laboratory of Time Reference and Applications, National Time Service Center, Chinese Academy of Sciences, Xi'an, Shaanxi 710600, China.
In this paper, two models for simulating the shot noise and electronic noise performances of resonant photodetectors designed for homodyne measurements are presented. One is based on a combination of a buffer and a low-noise amplifier, and the other is based on an operational amplifier. Through the comparisons between the numerical simulation results and the experimentally obtained data, excellent agreements are achieved, which show that the models provide a highly efficient guide for the development of a high signal-to-noise ratio (SNR) resonant photodetector.
View Article and Find Full Text PDFPhotonic Quantum State Tomography Using Free Electrons.
Phys Rev Lett
December 2024
Solid State Institute, Technion-Israel Institute of Technology, Haifa 32000, Israel.
The tomography of photonic quantum states is key in quantum optics, impacting quantum sensing, computing, and communication. Conventional detectors are limited in their temporal and spatial resolution, hampering high-rate quantum communication and local addressing of photonic circuits. Here, we propose to utilize free electron-photon interactions for quantum state tomography, introducing electron homodyne detection with potential for femtosecond-temporal and nanometer-spatial resolutions.
View Article and Find Full Text PDFDipole Moment of a Superatom.
Phys Rev Lett
November 2024
Department of Physics, University of Michigan, Ann Arbor, Michigan 48109, USA.
Homodyne detection is used to measure the (collective) atomic dipole moment for an atomic ensemble that is prepared in a superposition of spatially phased Dicke states having at most two excitations (a so-called "superatom"). Homodyne detection allows one to isolate the contributions to the radiated intensity that depend linearly on the average value of the collective atomic dipole moment operator. Depending on whether the atom-reference field interference is constructive or destructive, either super-Poisson or sub-Poisson statistics for the combined field is observed.
View Article and Find Full Text PDFAn integrated path differential absorption (IPDA) lidar for CH leakage monitoring is proposed and demonstrated. In the simplified all-fiber optical layout, a homemade InGaAs/InP single-photon detector (SPD) using multi-channel technique with multi-mode fiber coupling is used to increase the maximum count rate and coupling efficiency. The system is calibrated in intensity and frequency domains.
View Article and Find Full Text PDFMulti-photon Fock states have diverse applications such as optical quantum information processing. For the implementation of quantum information processing, Fock states should be generated within the telecommunication wavelength band, particularly in the C-band (1530-1565 nm). This is because mature optical communication technologies can be leveraged for transmission, manipulation, and detection.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!