Redox-active molecules that afford high charge density upon attachment to an electroactive surface are of interest for use in molecular-based information-storage applications. One strategy for increasing charge density is to covalently link a second redox center to the first in an architecture that uses the vertical dimension in essentially the same molecular footprint. Toward this end, a set of four new porphyrin dyads have been prepared and characterized. Each dyad consists of two zinc porphyrins, an intervening linker (p-phenylene or 4,4'-diphenylethyne), and a surface attachment group (ethynyl or triallyl group). The porphyrin dyads were attached to an electroactive Si(100) surface and interrogated via electrochemical and FTIR techniques. The charge density obtainable for the ethynyl-functionalized porphyrin dyads is approximately double that observed for an analogously functionalized monomer, whereas that for the triallyl-functionalized dyads is at most 40% larger. These results indicate that the molecular footprint of the former dyads is similar to that of a monomer while that of the latter dyads is larger. For both the ethynyl- and triallyl-functionalized porphyrin dyads, higher charge densities (smaller molecular footprints) are obtained for the molecules containing the 4,4'-diphenylethyne versus the p-phenylene linker. This feature is attributed to the enhanced torsional flexibility of the former linker compared with that of the latter, which affords better packed monolayers. The FTIR studies indicate that the adsorption geometry of all the dyads is qualitatively similar and similar to that of monomers. However, the dyads containing the 4,4'-diphenylethyne linker sit somewhat more upright on the surface than those containing the p-phenylene linker, generally consistent with the smaller molecular footprint for the former dyads. Collectively, the high surface charge density (34-58 muC.cm(-)(2)) of the porphyrin dyads makes these constructs viable candidates for molecular-information-storage applications.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jo0522761DOI Listing

Publication Analysis

Top Keywords

porphyrin dyads
24
charge density
16
molecular footprint
12
dyads
11
footprint dyads
8
smaller molecular
8
p-phenylene linker
8
porphyrin
6
charge
6
molecular
5

Similar Publications

Synthesis of Ni porphyrin-Ni 5,15-diazaporphyrin hybrid tapes.

Chem Sci

July 2024

Key Laboratory of Chemical Biology and Traditional Chinese Medicine Research (Ministry of Education of China), Key Laboratory of the Assembly and Application of Organic Functional Molecules of Hunan Province, College of Chemistry and Chemical Engineering, Hunan Normal University Changsha 410081 China

Ni porphyrin (P) and Ni 5,15-diazaporphyrin (DAP) hybrid tapes were synthesized by Suzuki-Miyaura cross-coupling reactions of - or β-borylated P with β-brominated DAP followed by intramolecular oxidative fusion reactions. -β doubly linked hybrid tapes were synthesized by oxidation of singly linked precursors with DDQ-FeCl. Synthesis of triply linked hybrid tapes was achieved by oxidation with DDQ-FeCl-AgOTf with suppression of peripheral β-chlorination.

View Article and Find Full Text PDF

Self-assembly of new donor-acceptor systems based on (5,10,15,20-tetraphenylporphinato)manganese(III)/(5,10,15,20-tetra-4-tert-butylphenylporphinato)manganese(III)/(octakis(4-tert-butylphenyl)tetraazaporphinato)manganese(III) acetate ((AcO)MnTPP/(AcO)MnTBPP/(AcO)MnTAP) and 4-(10-phenylanthracen-9-yl)pyridine (PyAn) was studied using fluorescence spectroscopy and mass spectrometry. It was found that the coordination complexes of 1 : 1 composition (dyads) are formed in toluene. The spectral properties, the chemical structures and redox behavior of the dyads were described using H NMR, IR, ESR spectroscopy and cyclic voltammetry, respectively.

View Article and Find Full Text PDF

Recognition of atomic-level difference in porphyrin dyads for self-sorted supramolecular polymer growth.

Nanoscale

November 2023

Department of Chemistry, Yonsei University, 50 Yonsei-ro, Seodaemun-gu, Seoul, 03722, Republic of Korea.

Porphyrin dyads (PDMs, where M = Zn and Cu) composed of diphenylporphyrin and tetraphenylporphyrin units, designated as DPDMs and TPDMs, respectively, exhibited remarkable differences in the molecular assemblies depending on the coordination metal ion. Furthermore, TPDMs showed self-sorting behavior during the formation of supramolecular assemblies through the recognition of atomic-level difference.

View Article and Find Full Text PDF

We synthesized three new dyads composed of a Zn porphyrin and -Re(bpy)(CO)Br (bpy = 2,2'-bipyridine) units, ZnP-Bpy[double bond, length as m-dash]Re ( = 4, 5, and 6), in which the porphyrin is directly connected at the -position through the 4-, 5-, or 6-position of the bpy. We investigated the relationships between the connecting positions and the photophysical properties as well as catalytic activity in the CO reduction reaction. The dyad connected through the 6-position, ZnP-6Bpy[double bond, length as m-dash]Re, showed obvious phosphorescence with a lifetime of 280 μs at room temperature, in ,-dimethylacetamide (DMA), whereas the other two dyads showed almost no phosphorescence under the same conditions.

View Article and Find Full Text PDF

Developing light-harvesting systems with efficient photoinduced charge separation and long-lived charge-separated (CS) state is desirable but still challenging. In this study, we designed a zinc porphyrin photosensitizer covalently linked with viologen (ZnP-V) that can be prepared into nanoparticles in aqueous solution. In DMF solution, the monomeric ZnP-V dyads show no electron transfer between the ZnP and viologen units.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!