Evidence for native-defect donors in n-type ZnO.

Phys Rev Lett

Semiconductor Research Center, Wright State University, Dayton, Ohio 45435, USA.

Published: November 2005

Recent theory has found that native defects such as the O vacancy V(O) and Zn interstitial Zn(I) have high formation energies in n-type ZnO and, thus, are not important donors, especially in comparison to impurities such as H. In contrast, we use both theory and experiment to show that, under N ambient, the complex Zn(I)-N(O) is a stronger candidate than H or any other known impurity for a 30 meV donor commonly found in bulk ZnO grown from the vapor phase. Since the Zn vacancy is also the dominant acceptor in such material, we must conclude that native defects are important donors and acceptors in ZnO.

Download full-text PDF

Source
http://dx.doi.org/10.1103/PhysRevLett.95.225502DOI Listing

Publication Analysis

Top Keywords

n-type zno
8
native defects
8
evidence native-defect
4
native-defect donors
4
donors n-type
4
zno
4
zno theory
4
theory native
4
defects vacancy
4
vacancy interstitial
4

Similar Publications

Cupric oxide (CuO) is a promising p-type semiconducting oxide used in many critical fields, such as energy conversion and storage, and gas sensors, which is attributed to its unique optoelectrical properties and cost-effectiveness. This work successfully deposited amorphous, pinhole-free, ultrathin CuO films using atmospheric pressure spatial atomic layer deposition (SALD) with copper(II) acetylacetonate and ozone as precursors. The growth rate increased from 0.

View Article and Find Full Text PDF

Accurate methods for detecting volatile organic compounds (VOCs) are essential for noninvasive disease diagnosis, with breath analysis providing a simpler, user-friendly alternative to traditional diagnostic tools. However, challenges remain in low-temperature VOC solid-state sensors, especially concerning their selectivity and functionality at room temperature. Herein, we present key insights into optimizing multiwalled carbon nanotubes (MWCNTs)/polyaniline (PANI) and ZnO nanocomposites for efficient, light-free selective acetone sensing.

View Article and Find Full Text PDF

The effect of hot isostatic pressing (HIP) on the thermoelectric power factor of zinc oxide (ZnO) has been examined. ZnO is expected to be a potential n-type oxide thermoelectric material that could enhance the thermoelectric conversion efficiency. The HIP treatment is useful for densifying the material and controlling crystal defects in the material by applying high temperatures and pressures simultaneously.

View Article and Find Full Text PDF

Multifunctional Optimization of MXene for Enhanced Comprehensive Performance of Crystal Silicon-MXene Back-Heterojunction Solar Cells.

Small

December 2024

LONGi Institute of Future Technology, and School of Materials & Energy, Lanzhou University, 222 South Tianshui Road, Lanzhou, Gansu, 730000, China.

Enhancing the cost-performance ratio is a fundamental objective for the advancement of the photovoltaic sector. In this context, the development of innovative solar cells that offer a straightforward device configuration but high performance is arguably the most crucial element. Herein, an undoped back-heterojunction crystalline silicon (c-Si) solar cell is endeavored to be crafted by simply drop-casting a TiCT MXene ethanol colloidal solution onto the backside of an n-type c-Si (n-Si) wafer.

View Article and Find Full Text PDF

Synthesis of TiO-ZnO n-n Heterojunction with Excellent Visible Light-Driven Photodegradation of Tetracycline.

Nanomaterials (Basel)

November 2024

Anhui Provincial Key Laboratory of Green Carbon Chemistry, School of Chemistry and Material Engineering, Fuyang Normal University, Fuyang 236037, China.

Article Synopsis
  • Zinc oxide-based photocatalysts are effective and affordable for breaking down tetracycline, but struggle with efficiency under visible light due to rapid recombination of electron-hole pairs.
  • Research showcases a n-n-type ZnO-TiO heterojunction that boosts degradation efficiency to 97% within 1 hour of visible light exposure, significantly outperforming pure zinc oxide.
  • This advancement in photocatalyst technology with improved stability and efficiency could lead to new applications and greater commercialization beyond what traditional ZnO solutions offer.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!