The role of door orientation on occupant injury in a nearside impact: a CIREN, MADYMO modeling and experimental study.

Traffic Inj Prev

Department of Orthopedics & Sports Medicine, Harborview Injury Prevention Center, University of Washington, Seattle, Washington 98014, USA.

Published: December 2005

Objective: This study addressed the effects of vehicle height mismatch in side impact crashes. A light truck or SUV tends to strike the door of a passenger car higher causing the upper border to lead into the occupant space. Conversely, an impact centered lower on the door, from a passenger car, causes the lower border to lead. We proposed the hypothesis that the type of injury sustained by the occupant could be related to door orientation during its intrusion into the passenger compartment.

Method: Data on door orientation and nearside occupant injuries were collected from 125 side impact crashes reported in the CIREN database. Experimental testing was performed using a pendulum carrying a frame and a vehicle door, impacting against a USDOT SID. The frame allowed the door orientation to be changed. A model was developed in MADYMO (v 6.2) using the more biofidelic dummies, BIOSID, and SIDIIs as well as USDOT SID.

Results: In side impact crashes with the lower border of the door leading, 81% of occupants sustained pelvic injury, 42% suffered rib fractures, and the rate of organ injury was 0.84. With the upper border leading, 46% of occupants sustained pelvic injury, 71% sustained rib fracture, and the rate of organ injuries per case increased to 1.13. The differences in the groups with respect to pelvic injury were significant at p = 0.01, rib fracture, p = 0.10, and organ injury, p = 0.001. Experimental testing showed that when the door angle changed from lower to upper border leading, peak T4 acceleration increased by 273% and pelvic acceleration decreased by 44%. The model demonstrated that when the door angle changed from lower to upper border leading, the USDOT SID showed a 29% increase in T4 acceleration and a 57% decrease in pelvic acceleration. The BIOSID dummy demonstrated a 36% increase in T1 acceleration, a 44% increase in abdominal rib 1 deflection, a 91% increase in thoracic rib 1 deflection, and a 33% decrease in pelvic acceleration.

Conclusions: These data add more insight to the problem of mismatch during side impacts, where the bumper of the striking vehicle overrides the door beam, causing the upper part of the door to lead the intrusion into the passenger compartment. Even with the same delta V and intrusion, with the upper border of the door leading, more severe chest and organ injuries resulted. This data suggests that door orientation should be considered when testing subsystems for side impact protection.

Download full-text PDF

Source
http://dx.doi.org/10.1080/15389580500256813DOI Listing

Publication Analysis

Top Keywords

door orientation
20
upper border
20
side impact
16
door
13
impact crashes
12
pelvic injury
12
border leading
12
mismatch side
8
door passenger
8
passenger car
8

Similar Publications

Purpose: Social support is a known facilitator of exercise for people with disability. A qualitative approach was used to understand current social support practices in community gyms for young adults with disability.

Methods: Embedded within a larger project "Getting Young adult Moving - Supporting Participation and Access to Recreation Centres" (GYM-SPARC), semi-structured interviews were completed with 25 gym staff, representing 29 community gym facilities across Victoria, Australia.

View Article and Find Full Text PDF

The functionality of materials is determined by their composition and microstructure, that is, the distribution and orientation of crystalline grains, grain boundaries and the defects within them. Until now, characterization techniques that map the distribution of grains, their orientation and the presence of defects have been limited to surface investigations, to spatial resolutions of a few hundred nanometres or to systems of thickness around 100 nm, thus requiring destructive sample preparation for measurements and preventing the study of system-representative volumes or the investigation of materials under operational conditions. Here we present X-ray linear dichroic orientation tomography (XL-DOT), a quantitative, non-invasive technique that allows for an intragranular and intergranular characterization of extended polycrystalline and non-crystalline materials in three dimensions.

View Article and Find Full Text PDF
Article Synopsis
  • - The research explores a new use for sugarcane bagasse waste, turning it into zinc oxide nanoparticles (ZnO-NPs) through a green synthesis method, which helps reduce environmental pollution while adding economic value.
  • - The study reports a high yield (96%) in producing ZnO-NPs using an aqueous extract of sugarcane bagasse, which were further processed to achieve 99.7% purity through calcination, with various characterization techniques applied to understand their properties.
  • - The resulting ZnO-NPs exhibited strong antibacterial, antifungal, and antiviral activities, outperforming non-calcined ZnO-NPs, and showed promising interactions with specific viral targets, highlighting their potential for real-world applications in health and environmental solutions
View Article and Find Full Text PDF

A Geometric Approach for the Calculation of the Nonrandomness Factor Using Computational Chemistry.

J Chem Eng Data

October 2024

LSRE-LCM-Laboratory of Separation and Reaction Engineering-Laboratory of Catalysis and Materials, Faculty of Engineering, University of Porto, Rua Dr. Roberto Frias, 4200-465 Porto, Portugal.

The nonrandomness factor (α) is a parameter related to the polarity (and consequent randomness of spatial orientation) of the molecules and is generally fixed between 0.20 and 0.47 since no technique has been developed so far for its accurate estimation.

View Article and Find Full Text PDF

In-cell measurements of the relationship between structure and dynamics to protein function is at the forefront of biophysics. Recently, developments in EPR methodology have demonstrated the sensitivity and power of this method to measure structural constraints in-cell. However, the need to spin label proteins ex-situ or use noncanonical amino acids to achieve endogenous labeling remains a bottleneck.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!