Effect of muscle fatigue on internal model formation and retention during reaching with the arm.

J Appl Physiol (1985)

Dept. of Mechanical and Aerospace Engineering, 4200 Engineering Gateway, Univ. of California, Irvine, CA 92697-3975, USA.

Published: February 2006

The motor system adapts to novel dynamic environments by forming internal models that predict the muscle forces needed to move skillfully. The goal of this study was to determine how muscle fatigue affects internal model formation during arm movement and whether an internal model acquired while fatigued could be recalled accurately after rest. Twelve subjects adapted to a viscous force field applied by a lightweight robot as they reached to a target. They then reached while being resisted by elastic bands until they could no longer touch the target. This protocol reduced the strength of the muscles used to resist the force field by approximately 20%. The bands were removed, and subjects adapted again to the viscous force field. Their adaptive ability, quantified by the amount and time constant of adaptation, was not significantly impaired following fatigue. The subjects then rested, recovering approximately 70% of their lost force-generation ability. When they reached in the force field again, their prediction of the force field strength was different than in a nonfatigued state. This alteration was consistent with the use of a higher level of effort than normally used to counteract the force field. These results suggest that recovery from fatigue can affect recall of an internal model, even when the fatigue did not substantially affect the motor system's ability to form the model. Recovery from fatigue apparently affects recall because the motor system represents internal models as a mapping between effort and movement and relies on practice to recalibrate this mapping.

Download full-text PDF

Source
http://dx.doi.org/10.1152/japplphysiol.00140.2005DOI Listing

Publication Analysis

Top Keywords

force field
24
internal model
16
muscle fatigue
8
fatigue internal
8
model formation
8
motor system
8
internal models
8
subjects adapted
8
adapted viscous
8
viscous force
8

Similar Publications

Identifying the Structure of Two-Dimensional ACuO (A = Na, K, Cs) Film on Cu(111) with Atomic Resolution.

J Phys Chem Lett

January 2025

College of Chemistry, Key Laboratory of Theoretical and Computational Photochemistry, Beijing Normal University, Beijing 100875, China.

The deposition of alkali metals on oxide surfaces has garnered significant interest due to their critical role in enhancing various catalytic processes. However, the atomic-scale characterization of these structures remains elusive, owing to the complex and competing interactions among the oxygen, the alkali metals, and the metal atoms within the oxides. In this work, we grew alkali metals (Na, K, Cs) on the copper oxide films on the Cu(111) surface and found the formation of hexagonally ordered monolayer films.

View Article and Find Full Text PDF

Computational investigation of the perylene-TCNQ complex: effects of chalcogen and fluorine substitutions.

J Mol Model

January 2025

Department of Chemistry, Birla Institute of Technology and Science, Pilani - K. K. Birla Goa Campus, Zuarinagar, 403726, Goa, India.

Context: Donor-acceptor (D-A) complexes, formed between two or more molecules held together by intermolecular forces, show interesting tunable properties and found applications in diverse fields, including semiconductors, catalysis, and sensors. In this study, we investigated the D-A complexes formed between perylene and 7,7,8,8-tetracyanoquinodimethane (TCNQ) and their chalcogen (S, Se) and fluorine derivatives. It was observed that interaction energies due to complex formation increase while the HOMO-LUMO gaps decrease with chalcogen substitutions.

View Article and Find Full Text PDF

Computationally Efficient Polarizable MD Simulations: A Simple Water Model for the Classical Drude Oscillator Polarizable Force Field.

J Phys Chem Lett

January 2025

University of Maryland Computer-Aided Drug Design Center, Department of Pharmaceutical Sciences, School of Pharmacy, University of Maryland, Baltimore, Maryland 21201, United States.

An improvement in the computational efficiency of polarizable force field simulations is made through the development of a polarizable Drude water model, SWM3, in combination with the use of Lennard-Jones Particle Mesh Ewald (LJPME) for the treatment of long-range LJ interactions. The experimental bulk properties, density, heat of vaporization, dielectric constant, and self-diffusion constant of the SWM3 model are accurately replicated at ambient condition. The temperature dependence of the bulk properties is also captured except for the density.

View Article and Find Full Text PDF

Nanoscale Manipulation of Single-Molecule Conformational Transition through Vibrational Excitation.

J Am Chem Soc

January 2025

Department of Chemistry and Biochemistry, University of California, San Diego, La Jolla, California 92093-0309, United States.

Controlling molecular actions on demand is a critical step toward developing single-molecule functional devices. Such control can be achieved by manipulating the interactions between individual molecules and their nanoscale environment. In this study, we demonstrate the conformational transition of a single pyrrolidine molecule adsorbed on a Cu(100) surface, driven by vibrational excitation through tunneling electrons using scanning tunneling microscopy.

View Article and Find Full Text PDF

Entropy-based methods for formulating bottom-up ultra-coarse-grained models.

J Chem Phys

January 2025

Department of Chemistry, Chicago Center for Theoretical Chemistry, James Franck Institute, and Institute for Biophysical Dynamics, The University of Chicago, Chicago, Illinois 60637, USA.

Bottom-up coarse-grained (CG) modeling is an effective means of bypassing the limited spatiotemporal scales of conventional atomistic molecular dynamics while retaining essential information from the atomistic model. A central challenge in CG modeling is the trade-off between accuracy and efficiency, as the inclusion of often pivotal many-body interaction terms in the CG force-field renders simulation markedly slower than simple pairwise models. The Ultra Coarse-Graining (UCG) method incorporates many-body terms through discrete internal state variables that modulate the CG force-field according to, e.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!