Effect of soil fulvic acid on nickel(II) sorption and bonding at the aqueous-boehmite (gamma-AIOOH) interface.

Environ Sci Technol

Department of Geosciences, Princeton University, Guyot Hall, Princeton, New Jersey 08544, USA.

Published: June 2005

The influence of soil-derived fulvic acid (SFA) on Ni(II) sorption and speciation in aqueous boehmite (gamma-AIOOH) suspensions was evaluated using a combination of sorption experiments and Ni K-edge extended X-ray absorption fine structure (EXAFS) spectroscopy measurements. Co-sorption of SFA at the aqueous-boehmite interface modifies both the extent of Ni(II) sorption as well as the local structure of the sorbing Ni(II) ions. In SFA-free suspensions, Ni(II) sorbs by forming inner-sphere bidentate mononuclear complexes with surface aluminol groups. Addition of SFA increases Ni(II) sorption at pH conditions below the sorption edge observed in SFA-free suspensions and diminishes Ni(II) sorption at pH above the SFA-free sorption edge. When SFA is co-sorbed to boehmite, Ni(II) sorbs by forming both ligand-bridging ternary surface complexes (Ni(II)-SFA-boehmite) as well as surface complexes in which Ni(II) remains directly bonded to aluminol groups, that is, binary Ni(II)-boehmite or metal-bridging ternary surface complexes (SFA-Ni(II)-boehmite). The relative contribution of the individual sorption complexes depends heavily on geochemical conditions; the concentration of ligand-bridging complexes increases with increasing SFA sorption and decreasing pH. The local structure of sorbed Ni(II) does not change with increasing reaction time even though the extent of sorption continues to increase. This supports a slow uptake mechanism where surface or intraparticle diffusion processes are rate-limiting. This work demonstrates that the association of humic constituents with soil minerals can significantly modify the mechanisms controlling trace metal sorption and transport in heterogeneous aquatic environments.

Download full-text PDF

Source
http://dx.doi.org/10.1021/es0481629DOI Listing

Publication Analysis

Top Keywords

niii sorption
16
sorption
12
surface complexes
12
niii
9
fulvic acid
8
local structure
8
sfa-free suspensions
8
niii sorbs
8
sorbs forming
8
aluminol groups
8

Similar Publications

Carbon-nanotube-modified biochar (CNT3-CBC) with a nanostructured surface was prepared by using cattle manure as the raw material via the impregnation method. This modified biochar was then used to adsorb petroleum and Ni(II) from aqueous solutions. Various physicochemical characterization techniques were employed, including SEM, BET analysis, FTIR, and XPS.

View Article and Find Full Text PDF

Selective recovery of Co(II), Mn(II), Cu(II), and Ni(II) by multiple step batch treatments with nanocellulose products.

Environ Sci Pollut Res Int

December 2024

Cellulose, Paper and Advanced Water Treatments Research Group, Department of Chemical Engineering, Complutense University of Madrid, Avda. Complutense S/N, Madrid, Spain.

The recovery of Co(II), Mn(II), Ni(II), and Cu(II) from black mass e-waste solutions through cellulose nanofibers (CNFs) and nanocrystals (CNCs) was investigated. These materials were synthetized by TEMPO-oxidation followed by high-pressure homogenization, and acid hydrolysis, respectively. The NC characterization included the measurement of consistency, cationic demand, carboxylic content, dissolved amorphous cellulose, and transmittance at λ = 600 nm.

View Article and Find Full Text PDF

Sorption of metal ions onto PET-derived microplastic fibres.

Environ Sci Process Impacts

December 2024

School of Chemistry and Chemical Engineering, University of Surrey, Guildford, Surrey GU2 7XH, UK.

Article Synopsis
  • This study explored how microplastic polyester fibers, specifically polyethylene terephthalate (PET), can absorb various metal ions found in sewage.
  • The research found that PET fibers could effectively retain metal ions like lead, cadmium, and mercury, with lead showing the highest absorption capacity.
  • The findings suggest that when these microplastics are present in sewage treatment, they can contribute to the transfer of hazardous metals into the environment, particularly when sewage sludge is used on agricultural land.
View Article and Find Full Text PDF

The removal of nickel from wastewater is a significant environmental concern because of its potential hazards to environment. Adsorption is known as an efficient water treatment strategy and there is a growing interest in the development of new adsorbent materials providing rapid adsorption kinetics, cost-effectiveness, and high adsorption capacity. In this study, the feasibility of MnO-MnOOH nanocomposites was evaluated as the adsorbent material for the removal of nickel ions from wastewater.

View Article and Find Full Text PDF

Effective removal of organic and inorganic impurities by adsorption technique requires the preparation of new materials characterized by low production costs, significant sorption capacity, and reduced toxicity, derived from natural and renewable sources. To address these challenges, new adsorbents have been developed in the form of polymer microspheres based on ethylene glycol dimethacrylate (EGDMA) and vinyl acetate (VA) (EGDMA/VA) containing starch (St) modified with boric acid (B) and dodecyl-S-thiuronium dodecylthioacetate (DiTDTA) for the removal of dyes: C.I.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!