Effects of pure n-alkanes and crude oil on bacterial phospholipid classes and molecular species determined by electrospray ionization mass spectrometry.

J Chromatogr B Analyt Technol Biomed Life Sci

Laboratoire de Chimie Analytique de l'Environnement, UMR 6171, IFR PMSE 112, Europôle de l'Arbois, BP 80, 13545 Aix-en-Provence Cedex 4, France.

Published: August 2005

Phospholipids are major components of bacterial membrane. Furthermore, the growth in vitro on xenobiotics such as n-alkanes, aromatic compounds or alkanols bring about to a bacterial membrane adaptive response. Concerning this work, we studied the membrane lipid composition of a hydrocarbon-degrading gram-positive bacterium (Corynebacterium sp.) on a soluble substrate and we detected four different phospholipid classes: phosphatidylglycerol, phosphatidylinositol, cardiolipin and acyl phosphatidylglycerol. In addition, a study of the lipid composition was performed after an in vitro culture on either pure n-alkane or crude oil. The growths on such hydrophobic substrates showed major qualitative and quantitative modifications. In the case of a growth on either heneicosane or crude oil, an increase of odd-numbered fatty acids was observed. Furthermore, the phospholipid polar head group composition was highly influenced by the crude oil addition. These modifications were, respectively, interpreted as the consequence of hydrocarbon assimilation and membrane fluidity adaptation. Finally, Corynebacterium sp. was taken back on the initial ammonium acetate substrate in order to determine its restoration abilities after a petroleum contamination.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jchromb.2005.05.014DOI Listing

Publication Analysis

Top Keywords

crude oil
16
phospholipid classes
8
bacterial membrane
8
lipid composition
8
effects pure
4
pure n-alkanes
4
crude
4
n-alkanes crude
4
oil
4
oil bacterial
4

Similar Publications

Fixed-point thickness measurement is commonly used in corrosion detection within petrochemical enterprises, but it suffers from low detection efficiency for localized thinning, limitations regarding measurement locations, and high equipment costs due to insulation and cooling layers. To address these challenges, this paper introduces a wireless passive ultrasonic thickness measurement technique based on a pulse compression algorithm. The research methodology encompassed the development of mathematical and circuit models for single coil and wireless energy transmission, the proposal of a three-terminal wireless energy mutual coupling system, and the establishment of a finite element model simulating the ultrasonic body wave thickness measurement and wireless energy transmission system.

View Article and Find Full Text PDF

In this paper, we investigated the efficient metal-free phosphorus-nitrogen (PN) catalyst and used the PN catalyst to degrade waste PU with two-component binary mixed alcohols as the alcohol solvent. We examined the effects of reaction temperature, time, and other factors on the hydroxyl value and viscosity of the degradation products; focused on the changing rules of the hydroxyl value, viscosity, and molecular weight of polyols recovered from degradation products with different dosages of the metal-free PN catalyst; and determined the optimal experimental conditions of reaction temperature 180 °C, reaction time 3 h, and PN dosage 0.08%.

View Article and Find Full Text PDF

Fats and Oils as a Sustainable Source of Photopolymerizable Monomers.

Polymers (Basel)

December 2024

Department of Applied Science and Technology, Politecnico di Torino, Corso Duca degli Abruzzi 24, 10129 Torino, Italy.

Bio-derived monomers and biobased building blocks obtained from natural sources, e.g., fats and oils, are attracting increasing attention mainly due to sustainability concerns.

View Article and Find Full Text PDF

One of the most challenging aspects of manipulating the flow of fluids in subsurfaces is to control their flow direction and flow behavior. This can be especially challenging for compressible fluids, such as CO, and for multiphase flow, including both water and carbon dioxide (CO). This research studies the ability of two crosslinked polymers, including hydrolyzed polyacrylamide and acrylic acid/hydrolyzed polyacrylamide crosslinked polymers, to reduce the permeability of both CO and formation water using different salinities and permeability values and in the presence of crude oil under different injection rates.

View Article and Find Full Text PDF

Vibration Welding of PLA/PHBV Blend Composites with Nanocrystalline Cellulose.

Polymers (Basel)

December 2024

Faculty of Materials Engineering and Physics, Cracow University of Technology, Warszawska 24, 31-155 Cracow, Poland.

Thermoplastic composites have garnered significant attention in various industries due to their exceptional properties, such as recyclability and ease of molding. In particular, biocomposites, which combine biopolymers with natural fibers, represent a promising alternative to petroleum-based materials, offering biodegradability and reduced environmental impact. However, there is limited knowledge regarding the efficacy of joining PLA/PHBV-based biocomposites modified with nanocrystalline cellulose (NCC) using vibration welding, which restricts their potential applications.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!