Triblock copolymer PLA-PEG-PLA were synthesized using ring opening polymerization with different LA/EG ratio. Micellar aggregates were prepared from these block copolymers and characterized. The degradation characteristics of selected copolymers were assessed in both micellar and film forms. Surface segregation of PEG was also quantified as a function of copolymer composition. Anti-cancer drugs 5-FU and paclitaxel were loaded into the micellar nanospheres with good efficiency. The drug release profile showed good control over the release of paclitaxel from these polymers.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.ijpharm.2005.03.023 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Emergence of ADM-mediated bioconjugate to enhance longevity and catalytic efficiency of urease.
Int J Biol Macromol
January 2025
School of Chemistry, University of Hyderabad, Gachibowli-500046, Hyderabad, Telangana State, India.
The versatile nature of the urease enzyme makes it a valuable asset in biological and industrial contexts. The creation of bioconjugates using enzyme-polymer combinations has extended the shelf life and stability of urease. A triblock copolymer, PAM-co-PDPA-co-PMAA@urease (ADM@urease), was synthesized using acrylamide (AM), 2,5-dioxopyrrolidin-1-ylacrylate (DPA), methacrylic acid (MAA), and urease via the RAFT-Grafting-To polymerization method.
View Article and Find Full Text PDFMelt electrowriting of amorphous solid dispersions: Influence of drug and plasticizer on rheology and printing performance.
Int J Pharm
January 2025
Soft Matter Chemistry, Department of Chemistry, and Helsinki Institute of Sustainability Science, Faculty of Science, University of Helsinki, PB55 00014 Helsinki, Finland. Electronic address:
Drug loaded microfiber scaffolds have potential for sublingual drug delivery due to their fast dissolution time and tunable porosity. Such microfiber scaffolds can be prepared by melt electrowriting (MEW), wherein a polymer melt is electrostatically drawn out of a syringe onto a computer controlled moving collector. The fabrication of such scaffolds via MEW has previously been shown for a polymer with a glass transition temperature (T) just above room temperature, making handling challenging.
View Article and Find Full Text PDFInfluence of Parameters Used to Prepare Sterile Solutions of Poloxamer 188 on Their Physicochemical Properties.
Polymers (Basel)
December 2024
Institute of Theoretical and Experimental Biophysics RAS, Pushchino 142290, Russia.
The physicochemical properties of emulsions based on poloxamers (triblock copolymers of a hydrophobic polyoxypropylene chain and two hydrophilic polyoxyethylene chains) depend on the composition and preparation method. This study examined the impact of poloxamer P188 concentration, autoclaving mode, heating, and salt presence on the viscosity, particle size distribution, and morphology of particles using viscometric analysis, dynamic light scattering (DLS), and atomic force microscopy (AFM). It was shown that sample preparation affects the particle size and morphology but not the chemical composition of P188.
View Article and Find Full Text PDFProbing Interparticle Interaction and Ordering in Silica-Pluronic-Based Solutions and Emulsions by Small-Angle Scattering Techniques.
J Phys Chem B
January 2025
Homi Bhabha National Institute, Anushakti Nagar, Mumbai 400094, India.
Introduction of non-DLVO forces by nonionic surfactants brings about fascinating changes in the phase behavior of silica nanosuspensions. We show here that alterations in the interaction and wetting properties of negatively charged silica nanoparticles (Ludox® LS) in the presence of polyethylene oxide-polypropylene oxide-polyethylene oxide-based triblock copolymers called Pluronics lead to the formation of stable o/w Pickering emulsions and interparticle attraction-induced thermoresponsive liquid-liquid phase separations. The results make interesting comparisons with those reported for Ludox® TM nanosuspensions comprising larger silica nanoparticles.
View Article and Find Full Text PDFPoly(-lysine)--poly(ethylene glycol)--poly(-lysine) triblock copolymers for the preparation of flower micelles and their irreversible hydrogel formation.
Sci Technol Adv Mater
November 2024
Department of Materials Science, Institute of Pure and Applied Sciences, University of Tsukuba, Tsukuba, Ibaraki, Japan.
Poly(-lysine)--poly(ethylene glycol)--poly(-lysine) (PLys--PEG--PLys) triblock copolymers formed polyion complex (PIC) with poly(acrylic acid) (PAAc) or sodium poly(styrenesulfonate) (PSS), leading to the formation of flower micelle-type nanoparticles (Nano or Nano) with tens of nanometers size in water at a polymer concentration of 10 mg/mL. The flower micelles exhibited irreversible temperature-driven sol-gel transitions at physiological ionic strength, even at low polymer concentrations such as 40 mg/mL, making them promising candidates for injectable hydrogel applications. Rheological studies showed that the chain length of PLys segments and the choice of polyanions significantly impacted irreversible hydrogel formation, with PSS being superior to PAAc for the formation.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!