In magnetic induction tomography reducing the influence of the primary excitation field on the sensors can provide a significant improvement in SNR and/or allow the operating frequency to be reduced. For the purposes of imaging, it would be valuable if all, or a useful subset, of the detection coils could be rendered insensitive to the primary field for any excitation coil activated. Suitable schemes which have been previously suggested include the use of axial gradiometers and coil-orientation methods (Bx sensors). This paper examines the relative performance of each method through computer simulation of the sensitivity profiles produced by a single sensor, and comparison of reconstructed images produced by sensor arrays. A finite-difference model was used to determine the sensitivity profiles obtained with each type of sensor arrangement. The modelled volume was a cuboid of dimensions 50 cmx50 cmx12 cm with a uniform conductivity of 1 S m-1. The excitation coils were of 5 cm diameter and the detection coils of 5 mm diameter. The Bx sensors provided greater sensitivity than the axial gradiometers at all depths, other than on the surface layer of the volume. Images produced using a single-planar array were found to contain distortion which was reduced by the addition of a second array.

Download full-text PDF

Source
http://dx.doi.org/10.1088/0967-3334/26/2/029DOI Listing

Publication Analysis

Top Keywords

magnetic induction
8
induction tomography
8
detection coils
8
axial gradiometers
8
sensitivity profiles
8
images produced
8
coils diameter
8
comparison sensors
4
sensors minimizing
4
minimizing primary
4

Similar Publications

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!