The potential of front-face fluorescence spectroscopy for the authentication of unifloral and polyfloral honey types (n = 57 samples) previously classified using traditional methods such as chemical, pollen, and sensory analysis was evaluated. Emission spectra were recorded between 280 and 480 nm (excit: 250 nm), 305 and 500 nm (excit: 290 nm), and 380 and 600 nm (excit: 373 nm) directly on honey samples. In addition, excitation spectra (290-440 nm) were recorded with the emission measured at 450 nm. A total of four different spectral data sets were considered for data analysis. After normalization of the spectra, chemometric evaluation of the spectral data was carried out using principal component analysis (PCA) and linear discriminant analysis (LDA). The rate of correct classification ranged from 36% to 100% by using single spectral data sets (250, 290, 373, 450 nm) and from 73% to 100% by combining these four data sets. For alpine polyfloral honey and the unifloral varieties investigated (acacia, alpine rose, honeydew, chestnut, and rape), correct classification ranged from 96% to 100%. This preliminary study indicates that front-face fluorescence spectroscopy is a promising technique for the authentication of the botanical origin of honey. It is nondestructive, rapid, easy to use, and inexpensive. The use of additional excitation wavelengths between 320 and 440 nm could increase the correct classification of the less characteristic fluorescent varieties.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/jf048384q | DOI Listing |
Spectrochim Acta A Mol Biomol Spectrosc
January 2025
Graduate School of Science and Technology, Niigata University, 8050 Ikarashi 2-no-cho, Nishi-ku, Niigata City, Niigata 950-2181, Japan. Electronic address:
To investigate the fluorescent properties of defects found on the surface of harvested soybeans, the front-face method was used to measure the Excitation Emission Matrix (EEM) on 106 samples of two varieties of soybeans to evaluate fluorescent properties according to defect type. The EEM showed four main peaks at Excitation/Emission (Ex/Em): 350-430 nm/420-510 nm, 410-450 nm/460-530 nm, 260-290 nm/300-350 nm and 210-230 nm/310-340 nm. In the Diseased, Pest, and Denatured (Black) soybeans, the above four main peaks were weakened.
View Article and Find Full Text PDFFood Chem
February 2025
Department of Food Quality and Safety Management, Poznań University of Life Sciences, ul. Wojska Polskiego 31/33, 60-624 Poznań, Poland.
The physicochemical characterization of fresh, undiluted, cold-pressed oil from elderberry seeds (EO) is presented. The results showed EO's uniqueness for the 93 % presence of essential fatty acids, including linoleic n-6 (41 %), α-linolenic n-3 (38 %), and oleic n-9 (13 %) acids with favorable ratios for human nutrition, n-3/n-6 = 0.93.
View Article and Find Full Text PDFFoods
September 2024
Department of Agricultural Sciences, Biotechnology and Food Science, Cyprus University of Technology, Limassol 3036, Cyprus.
The European Food Safety Authority (EFSA) has approved the use of a 1045 J/L UV-C dose as an adjunct to pasteurization to increase the shelf life and vitamin D3 content of milk. However, there are no verification methods analogous to the alkaline phosphatase test for pasteurized milk to ensure that the desired UV-C dose has been correctly applied. The aim is to develop a real-time in-line detector based on fluorescence spectroscopy.
View Article and Find Full Text PDFMikrochim Acta
July 2024
CLECEM Group, Department of Analytical Chemistry, University of Valencia, C/ Doctor Moliner, 50, 46100, Burjassot, Valencia, Spain.
A 3D-printed stereolithographic platform for selective biorecognition is designed to enable convective microscale affinity extraction of microcystin-LR (MC-LR) followed by direct solid-phase optosensing exploiting ratiometric front-face fluorescence spectroscopy. For this purpose, a recombinant monoclonal plantibody (recAb) is covalently attached to a 3D-printed structure for sorptive immunoextraction, whereupon the free and unbound primary amino moieties of the recAb are derivatized with a fluorescent probe. The fluorophore-recAb-MC-LR laden device is then accommodated in the cuvette holder of a conventional fluorometer without any instrumental modification for the recording of the solid-phase fluorescence emission.
View Article and Find Full Text PDFMethods Appl Fluoresc
June 2024
Institut für Berufswissenschaften im Bauwesen, Leibniz-Universität Hannover, Herrenhäuser Straße 8, 30419 Hannover, Germany.
This technical note presents a device to diminish scattering signal in front-face fluorescence spectra while obtaining fluorescence signal. The beam path in a commercial fluorescence spectrometer was modified by two deflecting mirrors, leading reflections away from the sensor. This light path modifying (LPM) device was tested with two fluid and three solid substances, where the scattering-to-fluorescence ratio improved by a factor of 1.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!