Correlation between accuracy of crowns fabricated using CAD/CAM and elastic deformation of CAD/CAM materials.

Dent Mater J

Department of Dental Materials Science, School of Dentistry at Niigata, The Nippon Dental University, 1-8 Hamauracho, Niigata-shi, Niigata 951-8580, Japan.

Published: December 2004

Full crowns were fabricated from three different materials (titanium, ceramic, and resin composite) at different rest diameters using a dental CAD/CAM system, and then their marginal discrepancy measured. The deflection of cylindrical specimens at 500 gf was measured using the same materials and diameters as for the accuracy measurement. Marginal discrepancy decreased as rest diameter increased, and at the same rest diameter the titanium crown had lower marginal discrepancy than ceramic and composite crowns. A significant correlation was found between marginal discrepancy of the crowns and deflection of the materials. This correlation was aptly expressed in the regression equation, MG = 4.54DF+53.9, where MG represented marginal discrepancy and DF represented deflection. This equation can be used as a good measure for new materials which have different modulus of elasticity.

Download full-text PDF

Source
http://dx.doi.org/10.4012/dmj.23.572DOI Listing

Publication Analysis

Top Keywords

marginal discrepancy
20
crowns fabricated
8
rest diameter
8
materials
5
marginal
5
discrepancy
5
correlation accuracy
4
crowns
4
accuracy crowns
4
fabricated cad/cam
4

Similar Publications

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!