Food habits and the evolution of energetics in birds of paradise (Paradisaeidae).

J Comp Physiol B

Department of Zoology, University of Florida, Gainesville, FL, 32611, USA.

Published: February 2005

Basal rates of metabolism, minimal thermal conductances, and body temperatures are reported for 13 species of birds of paradise that belong to nine genera. Body mass alone accounts for 91.7% of the variation in their basal rates. Basal rate in this family also correlates with food habits and the altitudinal limits to distribution. Species that feed almost exclusively on fruit have basal rates that average 79.4% of species in which >10% of the diet is insects, and species restricted to altitudes <1,000 m have basal rates that are 90.6% of those found at higher altitudes. The combination of body mass, food habits, and altitudinal distribution accounts for 99.0% of the variation in basal rate in the species studied. The application of food habits to a cladogram of the studied Paradisaeidae implies that frugivory and low basal rate were plesiomorphic in this family. The evolution of omnivory, defined as including >10% of the diet as insects, appears to have occurred at least twice, and in each case was associated with an increase in basal rate of metabolism. Basal rate increased at least thrice with a movement into the highlands. Basal rate, however, does not correlate with plumage dimorphism or with reproductive behavior. The basal rates of metabolism in manakins and birds of paradise, i.e., passerine frugivores, are greater than those found in nonpasserine frugivores. Thermal conductance correlates with body mass, which accounts for 85.8% of its variation in this family. Body temperature in paradisaeids, the mean of which was 40.2 degrees C, may correlate with basal rate of metabolism.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s00360-004-0468-7DOI Listing

Publication Analysis

Top Keywords

basal rate
20
basal rates
16
birds paradise
12
basal
9
food habits
8
rates metabolism
8
body mass
8
mass accounts
8
diet insects
8
rate metabolism
8

Similar Publications

Closure rate of full-thickness macular holes (FTMHs) with basal diameter >1000 μ is known to be poor. Patients presenting with FTMH having a minimum basal diameter of >1000 μ without any coexistent retinal morbidity were offered vitrectomy, internal limiting membrane peeling, retinal massage, and aspiration of subretinal fluid from the MH. Visual acuity (VA) and spectral-domain optical coherence tomography (SD OCT) assessments were performed at baseline, week 1 after surgery and at postoperative months 1, 3, 6, and 12.

View Article and Find Full Text PDF

Chemical corrosion resistance mechanism of titanium alloy radiation rods with self-protected structure.

Ultrason Sonochem

January 2025

State Key Laboratory of Precision Manufacturing for Extreme Service Performance, Central South University, Changsha 410083, China; Light Alloy Research Institute, Central South University, Changsha 410083, China.

The chemical corrosion of the TC4 radiation rod surface (TRRS) during the ultrasonic casting process has the potential to significantly impair the smooth conduction of ultrasonic waves. However, in the later stages of corrosion, a self-protected structure (TSPS) emerges under the ultrasonic cavitation effect, which serves to impede the chemical corrosion of the TRRS and markedly reduce the rate of mass loss of the radiation rod. This ensures the smooth ultrasonic conduction of the radiation rod during operation.

View Article and Find Full Text PDF

Skin cancer is one of the most prevalent malignancies in the world, with increasing incidence. In 2022, the World Health Organization estimated over 1.5 million new diagnoses of skin malignancies, primarily affecting the older population.

View Article and Find Full Text PDF

Damage mechanisms are a key factor in materials science and are essential for understanding and predicting the behavior of materials under complex loading conditions. In this paper, the influence of different directions, different rates and different model parameters on the mechanical behavior of AZ31 magnesium alloy during the tensile process is investigated based on the secondary development of the VUMAT user subroutine based on the GTN damage model and verified by the tensile experiments at different loading rates and in different directions. The results show that AZ31 magnesium alloy exhibits significant differences in mechanical properties in radial and axial stretching, where the yield strength is lower in the radial direction than in the axial direction, and the elongation is the opposite.

View Article and Find Full Text PDF

Combining Controlled-Release and Normal Urea Enhances Rice Grain Quality and Starch Properties by Improving Carbohydrate Supply and Grain Filling.

Plants (Basel)

January 2025

Jiangsu Key Laboratory of Crop Genetics and Physiology, Jiangsu Key Laboratory of Crop Cultivation and Physiology, Agricultural College, Yangzhou University, Yangzhou 225009, China.

Controlled-release nitrogen fertilizers are gaining popularity in rice ( L.) cultivation for their ability to increase yields while reducing environmental impact. Grain filling is essential for both the yield and quality of rice.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!