A thin specimen of a high density magnetic composite (HDMC), which is a type of powder magnetic cores was prepared for transmission electron microscopy (TEM) using a focused ion beam (FIB) method. A homogeneous thin film containing an insulator boundary between the constituent Fe powders was obtained successfully. Using this thin film, detailed flow of magnetic flux was visualized by electron holography, and the magnetic flux density was estimated to be 1.73 +/- 0.09 T being consistent with that of a bulk HDMC (1.70 T). Moreover, through Lorentz microscopy, the characteristic magnetization process of HDMC was observed by applying the magnetic field up to approximately 8 kA/m.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1093/jmicro/dfh072 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Asymmetric self-organization from a symmetric film by phase separation.
Nanoscale
January 2025
Department of Materials Science and Engineering, Kyushu Institute of Technology, 1-1 Sensui-cho, Tobata-ku, Kitakyushu 804-8550, Japan.
Self-organization realizes various nanostructures to control material properties such as superconducting vortex pinning and thermal conductivity. However, the self-organization of nucleation and growth is constrained by the growth geometric symmetry. To realize highly controlled three-dimensional nanostructures by self-organization, nanostructure formation that breaks the growth geometric symmetry thermodynamically and kinetically, such as tilted or in-plane aligned nanostructures, is a challenging issue.
View Article and Find Full Text PDFMolecular junctions (MJs) are celebrated nanoelectronic devices for mimicking conventional electronic functions, including rectifiers, sensors, wires, switches, transistors, negative differential resistance, and memory, following an understanding of charge transport mechanisms. However, capacitive nanoscale molecular junctions are rarely seen. The present work describes electrochemically (E-Chem) grown covalently attached molecular thin films of 10, 14.
View Article and Find Full Text PDFExtracting Thin Film Structures of Energy Materials Using Transformers.
ACS Phys Chem Au
January 2025
Neutron Scattering Division, Oak Ridge National Laboratory, Oak Ridge, Tennessee 37831, United States.
Neutron-Transformer Reflectometry Advanced Computation Engine (), a neural network model using a transformer architecture, is introduced for neutron reflectometry data analysis. It offers fast, accurate initial parameter estimations and efficient refinements, improving efficiency and precision for real-time data analysis of lithium-mediated nitrogen reduction for electrochemical ammonia synthesis, with relevance to other chemical transformations and batteries. Despite limitations in generalizing across systems, it shows promises for the use of transformers as the basis for models that could accelerate traditional approaches to modeling reflectometry data.
View Article and Find Full Text PDFComprehensive Study on the Thermoelectric Properties and Influencing Factors of Wearable Spiral Bracelets Enhanced by Radiation Cooling.
ACS Omega
January 2025
Key Laboratory of High Performance Ship Technology, Wuhan University of Technology, Ministry of Education, Wuhan 430063, China.
Wearable thermoelectric generator (TEG) can collect human body heat and convert it into electrical energy, achieving self-powering of the device and thus becoming a hot research topic at present. By utilization of three-dimensional spiral thin-film thermoelectric structures and passive radiation cooling methods, the heat transfer area can be increased and power generation can be enhanced. In order to study the effect of outdoor radiation cooling on the thermoelectric performance of spiral heating, as well as the TEG performance output under different external environments and circuit loads, this paper proposes a new three-dimensional coupled numerical model of the spiral thermoelectric wristband system with multiple physical fields.
View Article and Find Full Text PDFDesigning Robust Quasi-2D Perovskites Thin Films for Stable Light-Emitting Applications.
Adv Mater
January 2025
Department of Physics, SUNY University at Buffalo, Buffalo, NY, 14220, USA.
Quasi-2D perovskite made with organic spacers co-crystallized with inorganic cesium lead bromide inorganics is demonstrated for near unity photoluminescence quantum yield at room temperature. However, light emitting diodes made with quasi-2D perovskites rapidly degrade which remains a major bottleneck in this field. In this work, It is shown that the bright emission originates from finely tuned multi-component 2D nano-crystalline phases that are thermodynamically unstable.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!