Tailor-made functionalization of silicon nitride surfaces.

J Am Chem Soc

Laboratory of Organic Chemistry, Wageningen University, Dreijenplein 8, 6703 HB Wageningen, The Netherlands.

Published: July 2004

This communication presents the first functionalization of a hydrogen-terminated silicon-rich silicon nitride (Si3Nx) surface with a well-defined, covalently attached organic monolayer. Properties of the resulting monolayers are monitored by measurement of the static water contact angle, X-ray photoelectron spectroscopy (XPS), and infrared reflection absorption spectroscopy (IRRAS). Further functionalization was performed by reaction of Si3Nx with a trifluoroethanol ester alkene (CH2=CH-(CH2)8CO2CH2CF3) followed by basic hydrolysis to afford the corresponding carboxylic acid-terminated monolayer with hydrophilic properties. These results show that Si3Nx can be functionalized with a tailor-made organic monolayer, has highly tunable wetting properties, and displays significant potential for further functionalization.

Download full-text PDF

Source
http://dx.doi.org/10.1021/ja0483746DOI Listing

Publication Analysis

Top Keywords

silicon nitride
8
organic monolayer
8
tailor-made functionalization
4
functionalization silicon
4
nitride surfaces
4
surfaces communication
4
communication presents
4
presents functionalization
4
functionalization hydrogen-terminated
4
hydrogen-terminated silicon-rich
4

Similar Publications

We experimentally demonstrate what we believe to be a novel RF interference mitigation technique using a network of low-loss silicon nitride ring resonators. The rings are used for complex (phase and amplitude) line-by-line shaping of higher-order sidebands from an electro-optic modulator to discriminate large and small RF signal input, thereby achieving strong (30 dB) mitigation of a large signal and virtually no mitigation for small signals.

View Article and Find Full Text PDF

In this paper, we quantitatively compare the autofluorescence of stoichiometric low pressure chemical vapor deposition (LPCVD) silicon nitride and sputtered tantalum pentoxide waveguides at a pump wavelength of 532 nm. Through a direct quantitative characterization of comparable waveguides formed from the two films, we find no observable autofluorescence for tantalum pentoxide waveguides. Our experimental sensitivity is limited by Raman scattering of the pump into our detection band and our measurements indicate that the autofluorescence of the tantalum pentoxide waveguides is more than 600 × smaller than that of silicon nitride waveguides.

View Article and Find Full Text PDF

Silicon nitride (SiN) integrated photonics is a highly promising platform for photonic quantum information processing. However, the efficient generation of single photons remains a significant challenge. Epitaxial InAs/GaAs quantum dots (QDs) embedded in wavelength-scale nanocavities offer a promising solution as single-photon sources (SPSs), but their integration with SiN has not yet been demonstrated.

View Article and Find Full Text PDF

Localized Nanopore Fabrication in Silicon Nitride Membranes by Femtosecond Laser Exposure and Subsequent Controlled Breakdown.

ACS Appl Mater Interfaces

January 2025

Division of Micro and Nanosystems (MST), School of Electrical Engineering and Computer Science (EECS), KTH Royal Institute of Technology, Stockholm SE-10044, Sweden.

Controlled breakdown has emerged as an effective method for fabricating solid-state nanopores in thin suspended dielectric membranes for various biomolecular sensing applications. On an unpatterned membrane, the site of nanopore formation by controlled breakdown is random. Nanopore formation on a specific site on the membrane has previously been realized using local thinning of the membrane by lithographic processes or laser-assisted photothermal etching under immersion in an aqueous salt solution.

View Article and Find Full Text PDF

Scale-Up of Nanocorundum Synthesis by Mechanochemical Dehydration of Boehmite.

Ind Eng Chem Res

January 2025

Max-Planck-Institut für Kohlenforschung, Kaiser-Wilhelm-Platz 1, D-45470 Mülheim an der Ruhr, Germany.

This work presents the scale-up of room-temperature mechanochemical synthesis of nanocorundum (high-surface-area α-AlO) from boehmite (γ-AlOOH). This transformation on the 1 g scale using a laboratory shaker mill had previously been reported. High-energy Simoloyer ball mills equipped with milling chambers of sizes ranging from 1 to 20 L were used to scale up the mechanochemical nanocorundum synthesis to the 50 g to 1 kg scale, which paves the way to further increase batch size.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!