Hot electrons and optical emission are measured from the rear surface of a metallic foil. The spectra of the optical emission in the near infrared region have a sharp spike around the wavelength of the incident laser pulse. The optical emission is ascribed to coherent transition radiation due to microbunching in the hot electron beam. It is found that the optical emission closely correlates with the hot electrons accelerated in resonance absorption.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1103/PhysRevLett.92.165001 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Self-Sufficient Electrochromic Solar Cells: Photovoltaic and Color Modulating Smart Windows.
ACS Appl Mater Interfaces
January 2025
Department of Physics, Indian Institute of Technology Indore, Simrol 453552, India.
Electronic devices cover a large subset of daily life gadgets which use power to run, hence increasing the load of the energy needs and indirectly impacting greenhouse gas emissions. Smart electrochromic windows provide a solution to this through remarkable energy saving by adjusting optical behavior depending on the environmental conditions. Since the electrochromic windows also need power to run, a self-powered electrochromic panel will be a better solution.
View Article and Find Full Text PDFBound-States-in-the-Continuum-Induced Directional Photoluminescence with Polarization Singularity in WS Monolayers.
Nano Lett
January 2025
Department of Chemical Engineering, Pohang University of Science and Technology (POSTECH), Pohang 37673, Republic of Korea.
Monolayer transition metal dichalcogenides are promising materials that not only are atomically thin but also have direct bandgaps, making them highly regarded in optics and optoelectronics. However, their photoluminescence exhibits almost random polarization at room temperature. The emission is also omnidirectional and weak due to the low quantum yield.
View Article and Find Full Text PDFSpatial distribution of heavy metal assessment in beach sediment due to bauxite mining in Kuantan, Pahang, Peninsular Malaysia.
Environ Geochem Health
January 2025
Department of Biochemistry, College of Sciences, King Saud University, 11451, Riyadh, Saudi Arabia.
The effect of open-pit bauxite mining on beach sediment contamination in the urban coastal environment of Kuantan City, Malaysia, was investigated. The contents of 11 heavy metals (Pb, Cd, Al, Mn, Cu, Zn, Fe, As, Ni, Cr, and Ag) in 30 samples from Kuantan beach sediment zones (supratidal, intertidal, and subtidal) were determined using inductively coupled plasma optical emission spectrometry followed by contamination indexes, Pearson's correlation analysis, and principal component analysis (PCA). The results indicated that Cd, As, Ni, and Ag values in beach sediment zones were significantly higher compared to background values.
View Article and Find Full Text PDFPreliminary studies for the standardization of a pXRF analyzer ICP-OES for the accurate quantification of Pb in new paint.
Anal Methods
January 2025
Lead Exposure Elimination Project, London, W10 4BP, UK.
Determining lead (Pb) concentrations in new paints using spectroscopic methods such as Inductively Coupled Plasma-Optical Emission Spectroscopy (ICP-OES) requires technical expertise, consumables, equipment for method preparation, and instrumentation that can be cost prohibitive and difficult to maintain in low and middle-income countries (LMICs). Although portable X-ray Fluorescence (pXRF) analyzers are less expensive and simple to operate, their inaccuracy has limited their use to screening for the analysis of Pb in new, dried paint. To determine the limits of pXRF analyzers, new paint samples were purchased, dried, homogenized, and analyzed pXRF and ICP-OES.
View Article and Find Full Text PDFInside- and Outside-Coated PANI and/or PIN-TiO Nanotubes for Enhanced Photocatalytic Degradation of 4-Nitrophenol in Wastewater.
ACS Omega
December 2024
Department of Chemical and Petroleum Engineering, Sharif University of Technology, Tehran 1458889694, Iran.
We present a novel approach for enhancing photocatalytic efficiency by developing polyaniline (PANI) and polyindole (PIN)-coated TiO nanotubes (TNT) through a combination of chemical oxidation and hydrothermal processes. The PANI-PIN coating was systematically applied to both the internal and external surfaces of the nanotubes to enhance the photocatalytic active sites and optimize pollutant adsorption. The dual-coated structure enhances the interaction with pollutants, facilitating a more efficient degradation of 4-nitrophenol (4-NP) when exposed to visible light.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!