Adsorption of Cr(III) from wastewater by wine processing waste sludge.

J Colloid Interface Sci

Department of Environmental Engineering, National Ilan University, 1 Shen-nong Road, Ilan 260, Taiwan, Republic of China.

Published: May 2004

Wine processing waste sludge has been shown to be an effective adsorbent for the adsorption of Cr(III) from aqueous solution. The sludge has been characterized by scanning electron microscopy (SEM) and energy dispersive X-rays (EDX). The effect of pH, initial concentration of Cr(III), sludge particle size, and temperature on the adsorption studied. The equilibrium data could be described well by the Langmuir and Freundlich isotherm equations. A separation factor was used to judge the favorable adsorption. The calculated thermodynamic parameters, deltaH0 and deltaS0, are 1.95 kJ/mol and 27.16 J/molK, respectively. The deltaG0 values range from -5.98 to -6.79 J/mol, which shows the physical adsorption properties of the sludge. Adsorption dynamics had been successfully studied by the Lagergren model and an intraparticle diffusion model.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jcis.2003.12.051DOI Listing

Publication Analysis

Top Keywords

adsorption criii
8
wine processing
8
processing waste
8
waste sludge
8
adsorption
6
sludge
5
criii wastewater
4
wastewater wine
4
sludge wine
4
sludge effective
4

Similar Publications

In this study, kapok fiber (KF) a hollow and hydrophobic fiber, was modified with cetyltrimethylammonium bromide (CTAB) or cetylpyridinium chloride (CPC), rendering adsorbed amount of ∼0.75 × 10 mol/g. Small-angle X-ray scattering (SAXS) measurements of dry KF/CTAB and KF/CPC evidenced a periodic distance of ∼2.

View Article and Find Full Text PDF

Cr(vi) is highly toxic and carcinogenic, posing significant threats to health and ecosystems. This study utilizes solid waste from corncobs to synthesize biochar (CCBC) for the removal of Cr(vi) from water. The most effective Cr(vi) removal was achieved at pH 2.

View Article and Find Full Text PDF

Chromium isotope fractionation during the removal of hexavalent chromium by oak-based biochar.

Chemosphere

December 2024

Department of Earth and Environmental Sciences, University of Waterloo, 200 University Avenue West, Waterloo, ON, N2N 3G1, Canada. Electronic address:

Chromium, especially in its hexavalent form (Cr(VI)), poses significant health risks due to its carcinogenic properties. Emerging research suggests that biochar, a carbon-rich material derived from biomass pyrolysis, holds promise as an effective and sustainable solution for Cr(VI) remediation. Biochar's unique physicochemical properties, such as its high surface area, porous structure, and functional groups, contribute to its exceptional adsorption capacity for metals.

View Article and Find Full Text PDF

This research utilized tetraethylenepentamine-functionalized HY cubic zeolite as an adsorbent to effectively remove heavy metals from aqueous solutions. The adsorbent was characterized using FT-IR, XRD, TGA, FE-SEM, and EDS-MAP techniques. The synthesis aimed to optimize and evaluate the removal efficiency of Pb(II), Cr(III), Co(II), and Cu(II) from aqueous solutions by investigating key parameters, including initial pH, concentration, adsorbent dosage, and contact time.

View Article and Find Full Text PDF

New Schiff base covalently bonded graphene oxide for removing chromium(VI) from surface runoff.

Environ Res

January 2025

Guangdong Provincial Key Laboratory of Marine Biotechnology, Shantou University, Shantou, 515063, China.

Article Synopsis
  • - Hexavalent chromium (Cr(VI)) is a serious health and environmental hazard, particularly in industrial areas, and this study explores the use of modified graphene oxide (GO) as an effective adsorbent to tackle this issue.
  • - The synthesized adsorbent, GO/ATA, significantly improves adsorptive properties due to the attachment of a Schiff base, showcasing a high capacity of 243.3 mg/g for Cr(VI) removal at 298 K through electrostatic interactions and reduction reactions.
  • - GO/ATA demonstrates excellent recyclability, maintaining around 72.7% of its initial adsorption capacity after five cycles, confirming its practical use for remediating Cr(VI)-contaminated water and its potential
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!