The main objective of this study was to generate quantitative and qualitative emission data on phthalates from different materials. To achieve this the existing (Chamber for Laboratory Investigations of Materials, Pollution and Air Quality) Climpaq-based procedure for simplified measurements of emissions of plasticizer from PVC and other plasticized materials was modified. It was applied to a range of products. Some of them were suspected of contributing to the indoor concentration of plasticizers. The emissions from PVC flooring, polyolefine flooring, a refrigerator list, two electric cables, PVC skirting and floor wax were studied in separate Climpaqs. The emission from the PVC flooring in the Climpaq was compared with results from the ultra-small chamber Field and Laboratory Emission Cell (FLEC). Sampling and analysis methods were optimized to measure plasticizers. Samples were taken in exhaust air from the chambers after 6, 35, 62, 105, and 150 days from the start of the experiment. PVC flooring was tested for an additional 100 days. Polyolefine covered with wax resulted in an air concentration of 22 microg/m3 of dibutylphthalate (DBP), which is two orders of magnitude larger than any other materials, but did not emit di(2-ethylhexyl)phthalate (DEHP). The other materials resulted in max concentration of approximately 1 microg/m3 of DEHP and low emissions of DBP. The concentration of DEHP in each chamber increased slowly to a rather stable level which was reached after 150 days. DBP concentrations in the chambers with PVC skirting, PVC flooring, polyolefine and floor wax reached their quasi-static equilibrium after 60 days. The modified method did not create sufficient data for the calculation of emission rates. Adsorption of emission on chamber surfaces made it impossible to use the first part of the experiment for emission rate calculation. When the concentration had stabilized, it was found to be almost identical and independent of chamber and ventilation rate. Emission rates were reduced at high concentrations probably because the concentration in the material was near equilibrium with the concentration in the chamber air.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1046/j.1600-0668.2003.00220.x | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Increasing the Recycling of PVC Flooring Requires Phthalate Removal for Ensuring Consumers' Safety: A Cross-Checked Substance Flow Analysis of Plasticizers for Switzerland.
Environ Sci Technol
October 2024
Chair of Ecological Systems Design, Institute of Environmental Engineering, ETH Zürich, 8093 Zürich, Switzerland.
As our planet grapples with the severe repercussions of plastic pollution, mechanical recycling has been proposed as a potential remedy. However, increasing mechanical recycling may have unintended negative consequences. For example, recycling of PVC flooring containing hazardous plasticizers that were used in the past may lead to continued exposure.
View Article and Find Full Text PDFSilicone Irregular Hexagon Pessary Versus Polyvinyl Chloride Ring Pessary for Pelvic Organ Prolapse: Randomised Controlled Trial.
Int Urogynecol J
October 2024
Pelvic Floor Unit, The Royal Women's Hospital, 20 Flemington Rd, Parkville, VIC, 3052, Australia.
Introduction And Hypothesis: Vaginal pessaries are the mainstay of the non-surgical management of pelvic organ prolapse (POP). A flexible silicone irregular hexagonal (SIH) pessary was developed based on the results of a prior vaginal case study. We hypothesised that the SIH pessary would have a higher rate of retention and self-management than the polyvinyl chloride (PVC) pessary.
View Article and Find Full Text PDFEmissions of Semi-Volatile Organic Compounds from Architectural Coatings and Polyvinyl Chloride Floorings: Microchamber Method.
Molecules
September 2024
School of Chemistry and Biological Engineering, University of Science and Technology Beijing, Beijing 100083, China.
Semi-volatile organic compounds (SVOCs) are modern chemical substances that are present in large quantities in indoor environments. Understanding the emission of SVOCs from building materials is essential to identify the main sources of indoor SVOCs and to improve indoor air quality. In this study, a reference method employing custom-designed microchambers (630 mL) was optimized by improving the structure of the gas path and adding polytetrafluoroethylene inner coating to the chamber.
View Article and Find Full Text PDFMicroplastics in indoor air from Birmingham, UK: Implications for inhalation exposure.
Environ Pollut
December 2024
School of Geography, Earth and Environmental Sciences, University of Birmingham, Birmingham, B15 2TT, United Kingdom. Electronic address:
Microplastics (MPs) are a group of emerging contaminants that attracted increasing scientific and societal attention over the past decade. So far, most studies on MPs focus on characterizing their occurrence, fate, and impact in the aquatic environment. In contrast, very little is known about the magnitude, patterns, and associated risks of human exposure to MPs, particularly indoors, despite people spending most of their time indoors.
View Article and Find Full Text PDFEffects of surface-attached durations, nutrients, and relative humidity on the resuspension of bacteria during human walking.
J Hazard Mater
May 2024
School of Energy and Environment, City University of Hong Kong, Tat Chee Avenue, Kowloon, Hong Kong, China. Electronic address:
Resuspension caused by human walking activities is an important source of indoor bioaerosols and has been associated with health effects such as allergies and asthma. However, it is unknown whether inhalation of resuspended bioaerosols is an important exposure pathway for airborne infection. Also, crucial factors influencing the resuspension of settled microbes have not been quantified.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!