Nitric oxide diffusing capacity and alveolar microvascular recruitment in sarcoidosis.

Am J Respir Crit Care Med

Department of Internal Medicine, University of Texas Southwestern Medical Center, 5323 Harry Hines Boulevard, Dallas, TX 75390-9034, USA.

Published: May 2004

We measured diffusing capacities for carbon monoxide (DLCO) and nitric oxide, lung volume, and cardiac output by a rebreathing technique at two alveolar O2 tensions (PAO2) at rest and exercise. Membrane diffusing capacity for CO (DMCO) and VC were estimated from DLCO by the Roughton-Forster (RF) method and also from simultaneous lung diffusing capacity for NO and DLCO measured at one O2 tension (modified RF method). Estimates by these methods agreed closely in normal subjects (Tamhane et al., Chest 2001;120:1850-1856). Using these methods, we studied patients with stages II-III pulmonary sarcoidosis to determine (1) whether the modified RF method accurately estimates DMCO and VC in parenchymal disease and (2) whether sarcoidosis alters recruitment of diffusing capacity with respect to cardiac output. In patients, DMCO and VC estimated by the two methods agreed closely. DMCO was disproportionately reduced relative to VC at any given cardiac output, and the slope of the relationship between DLCO and cardiac output was moderately, though significantly, below normal. We conclude that in sarcoidosis (1) the modified RF method provides comparable estimates of DMCO and VC as the standard RF method and (2) the limitation to diffusive gas transport resides primarily in the membrane barrier, although recruitment of microvascular reserves is also modestly impaired.

Download full-text PDF

Source
http://dx.doi.org/10.1164/rccm.200309-1287OCDOI Listing

Publication Analysis

Top Keywords

diffusing capacity
16
cardiac output
16
modified method
12
nitric oxide
8
dmco estimated
8
methods agreed
8
agreed closely
8
estimates dmco
8
diffusing
5
dmco
5

Similar Publications

Ternary NASICON-Type NaVMnFe(PO)/NC@CNTs Cathode with Reversible Multielectron Reaction and Long Life for Na-Ion Batteries.

ACS Appl Mater Interfaces

January 2025

Key Laboratory of Low Carbon Energy and Chemical Engineering of Gansu Province, Lanzhou 730050, China.

Na superionic conductor (NASICON)-structure NaMnV(PO) (NVMP) electrode materials reveal highly attractive application prospects due to ultrahigh energy density originating from two-electron reactions. Nevertheless, NVMP also encounters challenges with its poor electronic conductivity, Mn dissolution, and Jahn-Teller distortion. To address this issue, utilizing N-doped carbon layers and carbon nanotubes (CNTs) for dual encapsulation enhances the material's electronic conductivity, creating an effective electron transport network that promotes the rapid diffusion and storage of Na.

View Article and Find Full Text PDF

Objectives: To evaluate the Medical Research Council (MRC) dyspnoea scale and serum Microfibrillar-associated protein 4 (MFAP4) levels for the detection of respiratory impairment in newly diagnosed rheumatoid arthritis (RA).

Methods: Patients underwent blood tests, pulmonary function tests (PFT) and dyspnoea assessment using the MRC scale. Respiratory impairment was defined as a diffusion capacity of the lungs for carbon monoxide (DLCO) <80% predicted or FEV1/FVC <70%.

View Article and Find Full Text PDF

Aqueous zinc-ion batteries are an appealing electrochemical energy storage solution due to their affordability and safety. Significant attention has been focused on vanadium oxide cathode materials for ZIBs, owing to their high specific capacity, unique layered or tunnel structures, and low cost. Compared to traditional methods for preparing and assembling electrode materials, direct current (DC) magnetron sputtering allows direct synthesis and uniform deposition on current collectors, offering advantages such as simplicity, mild reaction conditions, and strong film adhesion.

View Article and Find Full Text PDF

The rapid advancement of covalent organic frameworks (COFs) in recent years has firmly established them as a new class of molecularly precise and highly tuneable porous materials. However, compared to other porous materials, such as zeolites and metal-organic frameworks, the successful integration of hierarchical porosity into COFs remains largely unexplored. The challenge lies in identifying appropriate synthetic methods to introduce secondary pores without compromising the intrinsic structural porosity of COFs.

View Article and Find Full Text PDF

The main limitations of aqueous nickel-zinc batteries are their relatively low energy density and short cycle life, which are inextricably linked to the limitations of nickel-based cathodes. In this study, a low-crystallinity flower-like cobalt-doped nickel hydroxide (α-Ni(OH)-0.2Co) is constructed by hydrothermal reaction and employed as high-energy-density cathode for aqueous rechargeable nickel-zinc batteries.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!