The third-order nonlinear optical susceptibilities, chi(3), of composite films consisting of nanocrystalline Au and ZnO particles were investigated by use of a degenerate four-wave mixing scheme. The maximum value of chi(3), measured at a laser wavelength of 532 nm and a pulse duration of 70 ps, was approximately 2 x 10(-6) esu. Also, this chi(3) value was achieved with small absorption (the surface-plasmon peak was at the 615-nm wavelength). Our composite materials showed no discernible degradation after they were subjected to irradiation for a total of 3 x 10(7) high-intensity pulses (24 Mw/cm2, 70-ps pulse duration at 500 Hz) during 16 h of testing.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/ol.28.001790 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Single use plastics are a leading source of microplastics that have been detected along the food chain. This study evaluated the potential of starch (ST) and carrageenan (CRG) in packaging film formulation. CRG isolated from the seaweed (SW) was blended with starch and cast to obtain films whose moisture content (MC), total soluble matter (TSM), degree of solubility (DS), water vapor permeability (WVP), opacity (O), contact angles (CA), moisture absorption (MA), and percent elongation (PE) were evaluated.
View Article and Find Full Text PDFHigh-throughput evaluation of half-metallicity of CoMnSi Heusler alloys using composition-spread films and spin-integrated hard X-ray photoelectron spectroscopy.
Sci Technol Adv Mater
January 2025
Magnetic Functional Device Group, Research Center for Magnetic and Spintronic Materials (CMSM), National Institute for Materials Science (NIMS), Tsukuba, Japan.
We demonstrate high-throughput evaluation of the half-metallicity of CoMnSi Heusler alloys by spin-integrated hard X-ray photoelectron spectroscopy (HAXPES) of composition-spread films performed with high-brilliance synchrotron radiation at NanoTerasu, which identifies the optimum composition showing the best half-metallicity. Co Mn Si composition-spread thin films for = 10-40% with a thickness of 30 nm are fabricated on MgO(100) substrates using combinatorial sputtering technique. The 2-ordering and (001)-oriented epitaxial growth of CoMnSi are confirmed by X-ray diffraction for = 18-40%.
View Article and Find Full Text PDFMoxifloxacin-loaded PVA-chitosan composite films as potential ocular drug delivery systems: A comprehensive characterization and efficacy assessment.
Int J Biol Macromol
January 2025
Department of Pharmaceutics, School of Pharmacy, DRIEMS University, Tangi, Cuttack, Odisha, India. Electronic address:
To overcome the barriers often met by traditional ophthalmic formulations, polymeric films can be utilized as an alternative to enhance drug retention duration while managing medication release. In the current investigation, polymeric films made of poly (vinyl) alcohol (PVA) and chitosan (CS) loaded with Moxifloxacin Hydrochloride (M-HCl) and plasticized with Glutaraldehyde were formulated as potential ophthalmic delivery for the treatment of conjunctivitis. The thickness, surface pH, opacity, folding endurance, and % hemolysis were measured, followed by the transparency, microscopy, electrical conductivity, mechanical strength, swelling index, and invitro drug release studies.
View Article and Find Full Text PDFA PDMS/chitosan/MPMs composite film based on multi-field coupling enhancement for African swine fever virus P72 protein detection.
Mikrochim Acta
January 2025
Shanxi Key Laboratory of Micro Nano Sensors & Artificial Intelligence Perception, College of Integrated Circuits, Taiyuan University of Technology, Taiyuan, 030024, China.
African swine fever (ASF) is an acute hemorrhagic disease in pigs caused by the African swine fever virus (ASFV), which has a high mortality rate and brought great damage to global pig farming industry. At present, there is no effective treatment or vaccine to combat ASFV infection, so early detection of ASFV has become particularly important. Therefore, the PDMS/chitosan/MPMs composite film was proposed to detect ASFV P72.
View Article and Find Full Text PDFRoom-temperature and recyclable preparation of cellulose nanofibers using deep eutectic solvents for multifunctional sensor applications.
Int J Biol Macromol
January 2025
State Key Lab for Hubei New Textile Materials and Advanced Processing Technology, College of Materials Science & Engineering, College of Textile Science & Engineering, Wuhan Textile University, 430200 Wuhan, China. Electronic address:
Cellulose nanofibers (CNFs) have gained increasing attention due to their robust mechanical properties, favorable biocompatibility, and facile surface modification. However, green and recyclable CNF production remains challenging. Herein, a green, low-cost and room-temperature strategy was developed to exfoliate CNFs using deep eutectic solvents.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!