We have performed solid-state 31P-19F REDOR nuclear magnetic resonance (NMR) experiments to monitor changes in minor groove width of the oligonucleotide d(CGCAAA2'FUTGGC)*d(GCCAAT(pS)TT GCG) (A3T2) upon binding of the drug distamycin A at different stoichiometries. In the hydrated solid-state sample, the minor groove width for the unbound DNA, measured as the 2'FU7-pS19 inter-label distance, was 9.4 +/- 0.7 A, comparable to that found for similar A:T-rich DNAs. Binding of a single drug molecule is observed to cause a 2.4 A decrease in groove width. Subsequent addition of a second drug molecule results in a larger conformational change, expanding this minor groove width to 13.6 A, consistent with the results of a previous solution NMR study of the 2:1 complex. These 31P-19F REDOR results demonstrate the ability of solid-state NMR to measure distances of 7-14 A in DNA-drug complexes and provide the first example of a direct spectroscopic measurement of minor groove width in nucleic acids.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC212816 | PMC |
http://dx.doi.org/10.1093/nar/gkg720 | DOI Listing |
Clin Anat
December 2024
Division of Gross and Clinical Anatomy, Department of Anatomy, Kurume University School of Medicine, Fukuoka, Japan.
Shoulder pain often involves the tendon of the long head of the biceps brachii (LHBT) and the transverse humeral ligament (THL). Traditionally, the THL is considered a ligament that prevents the LHBT from dislocating, but recent studies suggest that it may be part of the subscapularis tendon. This review evaluates the nature of the THL and its overlying structures.
View Article and Find Full Text PDFRev Sci Instrum
December 2024
College of Intelligent Manufacturing, Long Dong University, Qingyang, Gansu 745000, China.
The deflector jet pressure servo valve (DJPSV), a critical component of the aircraft brake servo system, requires a precise foundational model for performance analysis, optimization, and enhancement. However, the complexity of the jet process within the V-groove of the deflector plate presents challenges for accurate mathematical modeling. To address this issue, the paper takes the DJPSV as the research object, carries out detailed mathematical modeling of its components, analyzes the influencing factors of the performance of the key component-the front stage-and optimizes the design of the key factors.
View Article and Find Full Text PDFMaterials (Basel)
December 2024
Department of Civil Engineering, Henan Vocational College of Water Conservancy and Environment, Zhengzhou 450008, China.
In order to investigate the interfacial bonding properties of high-strength steel stainless wire mesh-reinforced ECC (HSSWM-ECC) and concrete, a finite element model was established for two types of interfaces based on experimental research. The results show that the failure modes observed in the 21 groups of simulations can be classified into three categories: debonding failure, ECC extrusion failure and concrete splitting failure. The failure mode was mainly affected by the type of interface.
View Article and Find Full Text PDFSci Rep
December 2024
Graduate School of Medicine, Science and Technology, Shinshu University, 3-15-1 Tokida, Ueda, Nagano, 386-8567, Japan.
Biomimetic periodic structures have garnered attention due to their excellent water repellency. The normal-taper angle, which is aspects of the cross-sectional structure, is important factor in achieving water repellency and pressure resistance; however, the underlying physical phenomenon has not been fully explained. Moreover, once a surface becomes hydrophobic, it is difficult to measure the apparent contact angle.
View Article and Find Full Text PDFEur J Orthop Surg Traumatol
November 2024
McGovern Medical School, University of Texas Health Science Center at Houston, 5420 West Loop S. Suite 1300, Bellaire, TX, 77401, USA.
Purpose: Registry data shows that less surgeons are resurfacing the patella during total knee arthroplasty (TKA). This tendency highlights the importance of matching trochlear and native patellar anatomy. Currently, there is a lack of consensus on implant design that best accommodates native patellae.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!