The requirements of the Texas State Implementation Plan of the U.S. Clean Air Act for the Houston-Galveston Ozone Nonattainment Area stipulate large reductions in oxides of nitrogen (NO(x)) emissions. A large number of sources at Dow Chemical Co. sites within the nonattainment area may require the addition of continuous emission monitoring systems (CEMS) for online analysis of NO(x), CO, and O2. At the outset of this work, it was not known whether the analyzers could accurately measure NO(x) as low as 2 ppm. Therefore, NO(x) CEMS analyzers from five different companies were evaluated for their ability to reliably measure NO(x) in the 2-20 ppm range. Testing was performed with a laboratory apparatus that accurately simulated different mixtures of flue gas and, on a limited basis, simulated a dual-train sampling system on a gas turbine. The results indicate that this method is a reasonable approach for analyzer testing and reveal important technical performance aspects for accurate NO(x) measurements. Several commercial analyzers, if installed in a CEMS application with sampling conditioning components similar to those used in this study, can meet the U.S. Environmental Protection Agency's measurement data quality requirements for accuracy.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1080/10473289.2003.10466208 | DOI Listing |
FEBS J
January 2025
'The Protein Factory 2.0', Dipartimento di Biotecnologie e Scienze della Vita, Università degli Studi dell'Insubria, Varese, Italy.
The sequestration of carbon dioxide using carbonic anhydrase (CA) is one of the most effective methods for mitigating global warming. The burning of fossil fuels releases large quantities of flue gas; because of its high temperature and of the alkaline conditions required for CaCO precipitation in the mineralization process, thermo-alkali-stable CAs are needed. In this context, Manyumwa et al.
View Article and Find Full Text PDFChem Sci
January 2025
J. Mike Walker '66 Department of Mechanical Engineering, Texas A&M University College Station TX 77843 USA
This perspective work examines the current advancements in integrated CO capture and electrochemical conversion technologies, comparing the emerging methods of (1) electrochemical reactive capture (eRCC) though amine- and (bi)carbonate-mediated processes and (2) direct (flue gas) adsorptive capture and conversion (ACC) with the conventional approach of sequential carbon capture and conversion (SCCC). We initially identified and discussed a range of cell-level technological bottlenecks inherent to eRCC and ACC including, but not limited to, mass transport limitations of reactive species, limitation of dimerization, impurity effects, inadequate generation of CO to sustain industrially relevant current densities, and catalyst instabilities with respect to some eRCC electrolytes, amongst others. We followed this with stepwise perspectives on whether these are considered intrinsic challenges of the technologies - otherwise recommendations were disclosed where appropriate.
View Article and Find Full Text PDFACS Omega
January 2025
College of Safety Science & Engineering, Liaoning Technical University, Huludao, Liaoning 125105, China.
The objective of this study was to evaluate the effect of injecting flue gas (CO, N, and O) originating from coal-fired power plants into a coal seam on CH extraction and CO geological storage. To this end, a multifield thermal-fluid-solid-coupled mathematical model of flue gas injection extraction was established. The results showed that with the increase in time increase, the volume concentration of CH decreased, but the CO, N, and O increased.
View Article and Find Full Text PDFHeliyon
January 2025
Department of Chemical Engineering, University of Almería, Carretera de Sacramento s/n 04120 La Cañada de San Urbano, Almería, Spain.
This work studies the influence of flue gas composition, its moisture and ash content, on the efficiency of a CO adsorption/desorption process to capture the CO from flue gases along with its subsequent reuse in greenhouse CO enrichment (Patent ES2514090). The influence of the inlet flow rate, moisture, and ash content were analysed. The experimental conditions were based on those that are achievable under real operating conditions, namely an inlet flow rate from 1.
View Article and Find Full Text PDFBiostatistics
December 2024
Department of Biostatistics, Yale University School of Public Health, 60 College Street, New Haven, CT06511, United States.
Evaluating air quality interventions is confronted with the challenge of interference since interventions at a particular pollution source likely impact air quality and health at distant locations, and air quality and health at any given location are likely impacted by interventions at many sources. The structure of interference in this context is dictated by complex atmospheric processes governing how pollution emitted from a particular source is transformed and transported across space and can be cast with a bipartite structure reflecting the two distinct types of units: (i) interventional units on which treatments are applied or withheld to change pollution emissions; and (ii) outcome units on which outcomes of primary interest are measured. We propose new estimands for bipartite causal inference with interference that construe two components of treatment: a "key-associated" (or "individual") treatment and an "upwind" (or "neighborhood") treatment.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!