[Co(2,9-dimethyl-1,10-phenanthroline)(solvent)4]2+ ([Co(neo)]2+) undergoes a significant decrease in symmetry to form an inner-sphere surface complex when grafted directly on performed silica or introduced during the sol-gel process. The visible and X-ray absorption spectra of the surface adducts are interpreted in terms of a binding mode in which the Co(II) center has a highly distorted pseudo-C2v symmetry. The interaction of [Co(neo)]2+ with the silica surface was analyzed using an acid-base equilibrium relationship. Half-maximal surface binding was observed at pH ca. 6. Linear fits to the pH dependence data are consistent with inner-sphere binding of a single silanol group to the cobalt center. The formation of the surface species in tetramethoxyorthosilicate (TMOS) sol-gels required approximately 2 equiv of hydroxide anion per cobalt center, suggesting a two-proton-dependent binding event to form a species such as [Co(neo)(SiO)2]. Both sol-gel and silica samples showed essentially identical visible and X-ray absorption spectra, indicating formation of very similar surface adducts when the different synthesis procedures were employed. The maximal binding of [Co(neo)]2+ on three silica samples with different pore diameters and surface areas was compared. Increased binding was found to be inversely proportional to surface area and proportional to pore diameter, indicating a preference for less sterically demanding surface sites.

Download full-text PDF

Source
http://dx.doi.org/10.1021/ic025824rDOI Listing

Publication Analysis

Top Keywords

surface
9
visible x-ray
8
x-ray absorption
8
absorption spectra
8
surface adducts
8
cobalt center
8
formation surface
8
silica samples
8
binding
6
silica
5

Similar Publications

The Impact of Selenium on the Physiological Activity of Yeast Cells ATCC 7090 and CCY 20-2-26.

Front Biosci (Landmark Ed)

January 2025

Department of Food Biotechnology and Microbiology, Institute of Food Sciences, Warsaw University of Life Sciences - SGGW, 02-776 Warsaw, Poland.

Background: This study investigated the selenium-binding capacity of the biomass of two yeast strains, American Type Culture Collection (ATCC) 7090 and CCY 20-2-26.

Methods: The studies carried out methods of bioaccumulation by yeast biomass. Inorganic selenium was added to the culture media as an aqueous solution of NaSeO at concentrations ranging from 0 to 40 mg Se/L.

View Article and Find Full Text PDF

Background: In neuroscience, Ca imaging is a prevalent technique used to infer neuronal electrical activity, often relying on optical signals recorded at low sampling rates (3 to 30 Hz) across multiple neurons simultaneously. This study investigated whether increasing the sampling rate preserves critical information that may be missed at slower acquisition speeds.

Methods: Primary neuronal cultures were prepared from the cortex of newborn pups.

View Article and Find Full Text PDF

The environmental impact of chemicals used in aquaculture, particularly nitrofurantoin, has raised global concern. Nitrofurantoin, a broad-spectrum antimicrobial, is commonly used in aquaculture despite safety risks. Determination of nitrofurantoin in water samples of fish ponds is necessary to ensure the safety and quality of seafood.

View Article and Find Full Text PDF

Background: Surface electromyography (sEMG) has been used in a wide range of studies conducted in the field of dysphagia.

Objectives: The main aim of this case-control study is to obtain how submental and infrahyoid sEMG signals differ based on residue, penetration and aspiration.

Methods: A total of 100 participants (50 patients with suspected dysphagia and 50 healthy controls) were enrolled in the present study.

View Article and Find Full Text PDF

Polycyclic aromatic hydrocarbons (PAHs) are carcinogenic compounds resulting from incomplete burning of organic materials. This work describes the successful layer-by-layer fabrication of a novel zinc oxide nanocomposite made of zinc oxide nanoparticles, aniline, sodium dodecyl sulfate, and modified multi-walled carbon nanotubes on a stainless steel wire by electrodeposition. The coating and extraction conditions were screened, optimized, and validated using factorial design and central composite design, respectively.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!