Objectives: To evaluate the feasibility, accuracy and safety of chorionic villus sampling (CVS).

Methods: Ten thousand seven hundred and forty one singleton pregnancies at risk of chromosome abnormalities (96.3%) and gene disorders (2.8%) were referred from 1990 to 1999 to the fetal medicine unit of a teaching hospital. CVS was performed transabdominally after 11 weeks, using a modified freehand ultrasonographically guided technique by 5 operators. Fetal karyotyping was obtained using a direct method before 1995 and was completed by cell culture after 1996. Failed results, feto-placental discrepancy and fetal loss were assessed.

Results: Villi were sampled using extra-amniotic puncture (89.4%) and one sampling-device insertion (92.3%). The mean weight of the specimen was 15.2 +/- 6.0 mg. All attempts at sampling were successful, except eight (0.07%). The number of failed results following direct preparation, cell culture and both methods was 20 (0.19%), 23 (0.21%) and 2 (0.02%), respectively. Light maternal cell contamination occurred in less than 1% of the samplings after microscopic selection of the villi, and never interfered with the assessment of karyotyping. All 3 false-negative results (0.03%) were recorded after direct preparation and 2 were corrected by culture. The rate of chromosomal abnormalities confined to the placenta decreased from 1.08% before 1995 to 0.73% after 1996. True fetal mosaicisms were recorded in 7 cases (0.06%). The rate of fetal loss at <28 weeks was 1.64% in all pregnancies and 1.92% when CVS was performed before 13 weeks. Advanced maternal age was the single factor significantly associated with fetal loss.

Conclusions: CVS was feasible, accurate and safe in our institution, as a result of the increasing experience of the operators and the cytogeneticists.

Download full-text PDF

Source
http://dx.doi.org/10.1002/pd.578DOI Listing

Publication Analysis

Top Keywords

feasibility accuracy
8
accuracy safety
8
safety chorionic
8
chorionic villus
8
villus sampling
8
cell culture
8
fetal loss
8
direct preparation
8
fetal
5
sampling report
4

Similar Publications

Evaluating the feasibility of estimating particulate mass emissions of older-model diesel vehicle using smoke opacity measurements.

Sci Rep

December 2024

Clean Energy Technologies Research Institute (CETRI), Process Systems Engineering, Faculty of Engineering & Applied Science, University of Regina, 3737 Wascana Parkway, Regina, SK, S4S 0A2, Canada.

Real-world emissions of particulate matter (PM) and smoke opacity were studied for an older-model diesel pickup truck during four types of driving tests, namely fixed-point test, snap-acceleration test, road test, and hill road test (uphill/downhill). A portable emissions measurement system (PEMS) and an opacimeter were used to measure real-time concentrations of PM and smoke opacity, respectively, and simultaneously. Correlation analysis showed a significant positive association between PM and opacity, suggesting the feasibility of using an opacimeter to estimate PM mass emissions from diesel vehicles.

View Article and Find Full Text PDF

In recent years, inkjet digital printing technology has become a popular research area. This paper focuses on the spreading behavior of single ink drops on coated paper in digital inkjet printing. It explores the impact of ink drop spreading on monochromatic spectral reflectance, providing new insights for the theoretical development of spectral prediction models.

View Article and Find Full Text PDF

Transjugular intrahepatic portosystemic shunt (TIPS) is a widely used surgery for portal hypertensive patients, whose potential postoperative complications are closely related to the hemodynamic condition of the portal venous system. The selection of shunt position in the surgery may affect the postoperative hemodynamics; however, it is difficult for clinical studies to investigate the influence. Therefore, this study aims to employ the computational model simulating TIPS to compare the hemodynamic differences resulting from different shunt positions, and also to investigate the influences of different geometrical model simplification strategies used in the TIPS simulation.

View Article and Find Full Text PDF

Visible and Near-infrared hyperspectral imaging (VNIR-HSI) combined with machine learning has shown its effectiveness in various detection applications. Specifically, the quality of cigar tobacco leaves undergoes subtle changes due to environmental differences during the air-curing phase. This study aims to evaluate the feasibility of deep learning methods in overcoming data limitations to develop a VNIR-HSI prediction model for the quality of cigar tobacco leaves at different air-curing levels.

View Article and Find Full Text PDF

Background: Facial prosthetics are an important means to rehabilitate patients with congenital or acquired facial defects. However, with a time-consuming manual workflow and workforce shortage, access to facial prosthetics is limited in Australia and worldwide, especially for rural and remote patients. Optical 3D scanning has been increasingly integrated in digitizing data.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!