The magnitude of cutting forces at high speed.

Statement Of The Problem: Previous research has used a range of cutting forces for preparing teeth, but there are no data available on the forces actually imposed while cutting teeth with high-speed handpieces.

Purpose: The purpose of this study was to measure the forces imposed while cutting teeth with tungsten carbide burs used in high-speed handpieces.

Material And Methods: Thirty-one dentists each cut 8 conventional class II MO and DO preparations in intact extracted third molars, by use of 2 different air turbine handpieces with different torque-speed characteristics. Two different flat fissure, plain and cross-cut tungsten carbide burs, cutting wet and dry in each handpiece/bur combination. The teeth were mounted in a custom-made transducer unit that displayed the forces imposed by the bur. Data were analysed with a 1-way ANOVA (alpha =.05) and Spearman correlation test.

Results: The results showed that there was no significant difference in the applied force between plain and cross-cut burs, cutting wet or cutting dry, but there was a significant difference between the high and the lower torque handpieces. The higher torque handpiece was used at a mean cutting force of 1.44 N and the lower torque handpiece at 1.20 N (P<.002). The overall general mean force observed was 1.30 N.

Conclusion: It was concluded that the forces used in cutting teeth with the tungsten carbide burs tested related both to the type of the handpiece and to the forces chosen by clinical operators. There was no difference between the plain and cross-cut burs, there was no difference between the cutting wet or dry, and the higher torque handpiece required a higher mean cutting force.