The concentration gradient (Soret effect) induced in cw-laser thermal lens spectrometry subsequently to the formation of the thermal gradient (thermal lens effect) has been investigated in aqueous solutions of various macromolecular species including micelles, mixed micelles and polymers. It is shown that the build-up of the concentration gradient is much shorter than that in classical Soret experiments, reaching steady-state values in less than 1 min. The time evolution of the Soret signal has been used to derive mass-diffusion times from which mass-diffusion coefficients were calculated. Our data are in agreement with previous results obtained from quasi-elastic light scattering studies for the micellar solutions and calculated from a known molecular weight-dependent power law for polymer solutions.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/s1386-1425(02)00186-5 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Full Spectrum Electrochromic WO Mechanism and Optical Modulation via Ex Situ Spectroscopic Ellipsometry: Effect of Li Surface Permeation.
Micromachines (Basel)
December 2024
School of Physics, Changchun University of Science and Technology, Changchun 130012, China.
Tungsten oxide (WO) electrochromic devices are obtaining increasing interest due to their color change and thermal regulation. However, most previous work focuses on the absorption or transmission spectra of materials, rather than the optical parameters evolution in full spectrum in the electrochromic processes. Herein, we developed a systematic protocol of ex situ methods to clarify the evolutions of subtle structure changes, Raman vibration modes, and optical parameters of WO thin films in electrochromic processes as stimulated by dosage-dependent Li insertion.
View Article and Find Full Text PDFInterfacial Dripping Faucet: Generating Monodisperse Liquid Lenses.
Phys Rev Lett
December 2024
Carlos III University of Madrid, Thermal and Fluids Engineering Department, Avenida de la Universidad, 30 (Sabatini building), 28911 Leganés (Madrid), Spain.
We present a surface analog to a dripping faucet, where a viscous liquid slides down an immiscible meniscus. Periodic pinch-off of the dripping filament is observed, generating a succession of monodisperse floating lenses. We show that this interfacial dripping faucet can be described analogously to its single-phase counterpart, replacing surface tension by the spreading coefficient, and even undergoes a transition to a jetting regime.
View Article and Find Full Text PDFInfrared thermal modulation endoscopy for label-free tumor detection.
Sci Rep
December 2024
Department of Biomedical Science and Engineering, Gwangju Institute of Science and Technology, Gwangju, 61005, South Korea.
In optical imaging of solid tumors, signal contrasts derived from inherent tissue temperature differences have been employed to distinguish tumor masses from surrounding tissue. Moreover, with the advancement of active infrared imaging, dynamic thermal characteristics in response to exogenous thermal modulation (heating and cooling) have been proposed as novel measures of tumor assessment. Contrast factors such as the average rate of temperature changes and thermal recovery time constants have been investigated through an active thermal modulation imaging approach, yielding promising tumor characterization results in a xenograft mouse model.
View Article and Find Full Text PDFBioinspired Heterogeneous Surface for Radiative Cooling Enhanced Power-Free Moisture Harvesting in Unsaturated Atmosphere.
Adv Mater
December 2024
Key Laboratory of Material Chemistry for Energy Conversion and Storage, Ministry of Education, Hubei Key Laboratory of Material Chemistry and Service Failure and Hubei Engineering Research Center for Biomaterials and Medical Protective Materials, Huazhong University of Science and Technology, Wuhan, 430074, P. R. China.
The development of zero-power moisture-harvesting technology in an unsaturated atmosphere is of great significance for coping with global freshwater scarcity. Here, inspired by Pachydactylus rangei's (Namib sand gecko) ability to evade thermal radiation and harvest moisture, a power-free cooling moisture harvester (PFCMH) is fabricated using the continuous, industrialized micro-extrusion compression molding. A Luneburg lens is introduced in the PFCMH for the first time, endowing it with a high reflectivity of ≈92.
View Article and Find Full Text PDFGraphene-Inspired Wafer-Scale Ultrathin Gold Films.
Nano Lett
December 2024
National Graphene Institute (NGI), University of Manchester, Manchester M13 9PL, U.K.
As the trajectory toward the graphene era continues, there is a compelling need to harness 2D technology further for the transformation of three-dimensional (3D) materials production and applications. Here, we resolve this challenge for one of the most widely utilized 3D materials in modern electronics─gold─using graphene-inspired fabrication technology that allows us to develop a multistep production method of ultrathin gold films. Such films demonstrate continuous morphology, low sheet resistance (10 Ω/sq), and high transparency (80%), offering opportunities in a variety of technological and scientific sectors.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!