The frequency and clinical differences between several types of TGA have been estimated. In a group of 52 patients with TGA three anatomic types were distinguished on the basis of the classification of Nadas (Fig. 1). The correlation between TGA type and sex, weight at birth, predominating clinical symptoms, most frequent clinical complications and survival time in children with this congenital malformation were investigated (Fig. 1-6). Type I was found almost five times more frequently in boys who had a higher than average weight at birth (Fig. 1-3). The most frequent clinical symtpoms were: cyanosis, early congestive heart failure and paroxysmal anoxemia (Fig. 4). Infants with this TGA type died much earlier than infants with other TGA types (Fig. 6). The frequency of type IIA was the lowest, similar in both sexes (Fig. 1). Among clinical symptoms cyanosis, paroxysmal anoxemia and systolic murmurs prevailed. No congestive heart failure was observed in this type (Fig. 4). Type IIC was more frequent in boys, but simultaneously it was the most frequent TGA type noticed in female infants (Fig. 1). Almost in all children heart murmurs were found, but only one of the examined cases with this type was affected by congestive heart failure (Fig. 4). The above-mentioned differences between clinical symptoms of several types of transposition of great arteries can be helpful when the adequate treatment is chosen.
Download full-text PDF |
Source |
---|
Polymers (Basel)
January 2025
Department of Biochemistry, Institute for Biological Research "Siniša Stanković"-National Institute of the Republic of Serbia, University of Belgrade, Bulevar despota Stefana 142, 11060 Belgrade, Serbia.
Novel ferrite/polyurethane nanocomposites were synthesized using the in situ polymerization method after the addition of different spinel nanoferrite particles (copper, zinc, and copper-zinc) and examined as potential coatings for medical devices and implants in vascular tissue engineering. The influence of the nanoferrite type on the structure and functional characteristics of the polyurethane composites was investigated by FTIR, SWAXS, AFM, TGA, DSC, nanoindentation, swelling behavior, water contact angle, and water absorption measurements. Biocompatibility was evaluated by examining the cytotoxicity and adhesion of human endothelial cells and fibroblasts onto prepared composites and performing a protein adsorption test.
View Article and Find Full Text PDFChemistry
January 2025
Middle East Technical University: Orta Dogu Teknik Universitesi, Chemistry, Universiteler Mah., 06800, Cankaya, TURKEY.
This study introduces a new donor group capable of activating click-type [2+2] cycloaddition-retroelectrocyclizations, generally known for their limited scope. Target chromophores were synthesized using isocyanate-free urethane synthesis. The developed synthetic method allows for the tuning of the optical properties of the chromophores by modifying the donor groups, the acceptor units, and the side chains.
View Article and Find Full Text PDFRSC Adv
January 2025
Packing and Packaging Materials Department, Institute of Chemical Industries Research, National Research Centre 33 El Behooth St., Dokki Giza Egypt +20 2 33371718.
Nanofiltration (NF) separation technology is a low-pressure filtration process, which is highly efficient and environmentally friendly. As a result, it has found wide application in water treatment. This work describes the preparation of flat sheet membranes the phase inversion method using blends of hyperbranched polyester amide (PEA) and polyether sulphone (PES) in definite ratios.
View Article and Find Full Text PDFJ Phys Chem C Nanomater Interfaces
January 2025
Center for Materials Science and Nanotechnology (SMN), Department of Chemistry, University of Oslo, P.O. Box 1033, Blindern, Oslo N-0315, Norway.
The flexibility of the H-ZSM-5 zeolite upon adsorption of selected coke precursors was investigated using both theoretical and experimental approaches. Four structural models with varying active site locations were analyzed through density functional theory (DFT) simulations to determine their responses to different types and quantities of aromatic molecules. Complementary experimental analysis was performed, allowing for a direct comparison with the theoretical findings, using thermogravimetric analysis (TGA), nitrogen adsorption (N adsorption), solid-state NMR, and X-ray diffraction (XRD).
View Article and Find Full Text PDFACS Omega
January 2025
Swedish Centre for Resource Recovery, Faculty of Textiles, Engineering and Business, University of Borås, 501 90 Boras, Sweden.
This study investigates the morphology and thermo-mechanical properties of cross-linked polyethylene (PEX) pipes for potential use in high-temperature borehole thermal energy storage systems. Particular attention is given to a novel type of PEX pipe produced through photoinitiated cross-linking (PEX-e). Two formulations, PEX-e1 and PEX-e2, were analyzed and compared to peroxide-cross-linked polyethylene (PEX-a) and non-cross-linked bimodal polyethylene (PE100) pipes.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!