Shoulder prosthesis in reconstruction of the scapulohumeral girdle after wide resection to treat malignant neoformation of the proximal humerus.

Chir Organi Mov

Divisione di Ortopedia e Traumatologia Ospedale San Pietro Fatebenefratelli, Roma.

Published: October 2002

Progress in preoperative chemotherapy and radiation therapy, both intra- and postoperative, has in time allowed for an increase in indications for shoulder implant surgery in malignant tumors, thus drastically reducing the number of amputations. The use of prostheses, particularly those of the more recent generation, respond to the needs to overcome the limits of loss of movement, as long as good anatomical reconstruction of the soft tissues, the premise for good functional and cosmetic recovery, is also possible. The current tendency is that of using modular shoulder prostheses that provide a wide variety of sizes. This type of prosthesis has surpassed custom made prostheses in terms of simplicity, adaptability and economy. The use of cementation in stabilization of the intramedullary stem has made them more stable even in the long term, allowing for early rehabilitation. The main problem in reconstruction with a prosthesis is the quantity of residual muscular tissue (deltoideus, extrarotators) and the stabilization system of the same to the prosthesis in order to avoid dislocation, which constitutes the main complication. It is the purpose of this study to present the clinical and functional results obtained in 23 implants carried out for primary malignant neoformation of the upper limb. The implants studied were of three types (custom made, modular in Cr-Co-Mb and Ti-Al-Va). The results reported show how a shoulder prosthesis can obtain good functional results, particularly when a part of the activator muscles of the shoulder such as the deltoideus and the extrarotators is preserved. When the contrary is true, the results obtained are modest because the prosthesis acts as a simple spacer.

Download full-text PDF

Source

Publication Analysis

Top Keywords

shoulder prosthesis
8
malignant neoformation
8
good functional
8
deltoideus extrarotators
8
shoulder
5
prosthesis
5
prosthesis reconstruction
4
reconstruction scapulohumeral
4
scapulohumeral girdle
4
girdle wide
4

Similar Publications

Introduction: The aim of this study is to analyse the most cited articles in shoulder arthroplasty surgery and identify trends in topics by decade.

Methods: Journal Citation Index Web of Science (WoS) was searched to find articles using the search terms "shoulder arthroplasty", "shoulder hemiarthroplasty", "shoulder replacement" and "shoulder prosthesis". All articles were ranked according to most cited overall and most cited between 2022 and 2023, and then further analysed to find the most cited articles per decade.

View Article and Find Full Text PDF

Objective: Revision surgeries for periprosthetic joint infections (PJIs) in arthroplasty can follow either one- or two-stage treatment protocols. Previous studies have reported similar reinfection rates and reductions in complication rates for both treatment options. However, the literature on the selection of one protocol is still controversial.

View Article and Find Full Text PDF

The importance of the subscapularis tendon in reverse shoulder arthroplasty (RSA) has been increasingly emphasized lately. Recent studies have indicated that a repaired subscapularis tendon has better functional outcomes. This study is aimed at comparing the healing rate of repaired subscapularis tendons between onlay and inlay Bony Increased Offset-Reversed Shoulder Arthroplasty (BIO-RSA).

View Article and Find Full Text PDF

Acromial stress fractures and reactions after reverse total shoulder arthroplasty: a case-control study.

J Shoulder Elbow Surg

January 2025

Melbourne Shoulder and Elbow Centre, Sandringham, VIC, Australia; Department of Surgery, School of Clinical Sciences Monash Health, Monash University, VIC, Australia.

Background: Acromial stress fractures can occur after reverse total shoulder arthroplasty (RTSA). We performed this study to assess the incidence, risk factors, characteristics, and outcome of acromial stress fractures and reactions after RTSA.

Methods: We determined the incidence of acromial stress fractures and reactions in a cohort of patients who underwent RTSA, and assessed risk factors using a case-control design.

View Article and Find Full Text PDF

Objective: The use of vertical margin design in all-ceramic restoration has generated inquiries regarding its clinical efficacy under diverse dynamic oral conditions. This research aims to assess the marginal fit and fracture resistance of monolithic zirconia crowns featuring vertical margin design as opposed to those with conventional horizontal margin design.

Materials And Methods: Two metal dies were employed to generate replicated resin dies mimicking mandibular first molar preparation.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!