The surface characteristics of activated carbon as affected by ozone and alkaline treatment.

Chemosphere

Department of Environmental Engineering, Fooyin Institute of Technology, Kaohsiung Hsien, Taiwan, ROC.

Published: April 2002

The surface chemical characteristics of activated carbon treated by ozone and alkaline are determined in terms of surface functional groups and surface acidity. Surface functional groups are analyzed by the IR spectroscopic method and Boehm's titration technique. The surface acidity of activated carbon is determined by electrophoretic mobility measurements. The oxygen concentration of activated carbon increases upon ozone and NaOH treatment. Surface functional groups increase mostly in the hydroxyl and carboxyl categories rather than the carbonyl category upon ozone and NaOH treatment.

Download full-text PDF

Source
http://dx.doi.org/10.1016/s0045-6535(01)00215-6DOI Listing

Publication Analysis

Top Keywords

activated carbon
16
surface functional
12
functional groups
12
characteristics activated
8
ozone alkaline
8
treatment surface
8
surface acidity
8
ozone naoh
8
naoh treatment
8
surface
7

Similar Publications

What is left in miombo woodlands? Rarity and commonness of woody species, commercial timber species, and lawful harvestable diameter classes.

Heliyon

January 2025

Departamento de Engenharia Florestal, Universidade Eduardo Mondlane, Av. Julius Nyerere Número 3453, Campus Universitário Principal, Edifício Número 1, 257, Maputo, Mozambique.

Mozambican miombo woodlands (MWs) have been experiencing severe anthropogenic threats, recognized to have an impact on plant species distribution, occurrence, diversity, and rarity patterns. Based on 3725 0.1 ha plots distributed across the country's MWs, this study aimed to assess the species rarity and commonness, protection status, and availability of commercial timber in MWs under varied environmental conditions.

View Article and Find Full Text PDF

Removal of Cr(VI) from aqueous solutions by activated carbon and its composite with PWO: A spectroscopic study to reveal adsorption mechanism.

Heliyon

January 2025

Nuclear Chemistry Division, Department of Chemistry, Atomic Energy Commission, P. O. Box: 9061, Damascus, Syrian Arab Republic.

Molecular scale information is needed to understand ions coordination to mineral surfaces and consequently to accelerate the design of improved adsorbents. The present work reports on the use of two-dimensional correlation Fourier Transform infra-red spectroscopy (2D-COS-FTIR) and hetero 2D-COS-FTIR- X-ray diffraction (XRD) to probe the mechanism of Cr(VI) removal from aqueous solutions by activated carbon (AC) and its composite with PWO (AC-composite). The adsorption data at an initial Cr(VI) concentration of 320 mg L (320 ppm) revealed maximum adsorption capacities of 65 mg g for AC and 73 mg g for AC-composite, corresponding to removal percentages of 83 % and 94 %, respectively.

View Article and Find Full Text PDF

While many chemicals are regulated and routinely monitored in drinking water, they represent just a portion of all contaminants that may be present. Typical drinking water analyses involve sampling one liter or less of water, which could lead to trace level contaminants going undetected. In this study, a method was developed for using point-of-use activated carbon block drinking water filters as sampling devices.

View Article and Find Full Text PDF

Carbon catabolite repression (CCR) and de-repression (CCDR) are critical for fungal development and pathogenicity, yet the underlying regulatory mechanisms remain poorly understood in pathogenic fungi. Here, we identify a serine/threonine protein phosphatase catalytic subunit, Pp4c, as essential for growth, conidiation, virulence, and the utilization of carbohydrates and lipids in Magnaporthe oryzae. We demonstrate that the protein phosphatase 4 complex (Pp4c and Smek1 subunits), the AMP-activated protein kinase (AMPK) Snf1, and the transcriptional regulators CreA (repressor) and Crf1 (activator) collaboratively regulate the utilization of non-preferred carbon sources.

View Article and Find Full Text PDF

Although microporous carbons can perform well for CO2 separations under high pressure conditions, their energy-demanding regeneration may render them a less attractive material option. Here, we developed a large-pore mesoporous carbon with pore sizes centered around 20-30 nm using a templated technical lignin. During the soft-templating process, unique cylindrical supramolecular assemblies form from the copolymer template.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!