Water diffusion in hydrated crystalline and amorphous sugars monitored using H/D exchange.

J Pharm Sci

Solid State Analysis, Pharmaceutical and Analytical R&D, AstraZeneca R&D Mölndal, S-431 83 Mölndal, Sweden.

Published: March 2002

Water interacts with pharmaceutical materials in a number of different ways. The aim of this study was to investigate if exchange experiments with D(2)O can provide useful insights into the structure of hydrated materials. Raffinose pentahydrate, trehalose dihydrate, and sucrose were used as model compounds in conjunction with their amorphous counterparts. Following exposure to D(2)O vapor, the exchange of water of hydration and/or hydroxyl groups was monitored using Raman spectroscopy. For the amorphous materials, all of the sugar hydroxyl groups were found to exchange on exposure to D(2)O, providing evidence that water has no fixed site in amorphous materials, nor is access to different parts of the molecule restricted. For raffinose pentahydrate and trehalose dihydrate, exchange of both hydrate water and hydroxyls was incomplete, suggesting that there are specific pathways for diffusion into and within the crystal structure. The results are rationalized based on the known crystal structures. Using exchange experiments to investigate hydrates thus appears to be a useful probe of structure.

Download full-text PDF

Source
http://dx.doi.org/10.1002/jps.10068DOI Listing

Publication Analysis

Top Keywords

exchange water
8
exchange experiments
8
raffinose pentahydrate
8
pentahydrate trehalose
8
trehalose dihydrate
8
exposure d2o
8
hydroxyl groups
8
amorphous materials
8
exchange
6
water
5

Similar Publications

Anion Exchange Membranes (AEMs) are promising materials for electrochemical devices, such as fuel cells and electrolyzers. However, the main drawback of AEMs is their low durability in alkaline operating conditions. A possible solution is the use of composite ionomers containing inorganic fillers stable in a basic environment.

View Article and Find Full Text PDF

Enhanced Performance and Durability of Pore-Filling Membranes for Anion Exchange Membrane Water Electrolysis.

Membranes (Basel)

December 2024

Department of Green Chemical Engineering, College of Engineering, Sangmyung University, Cheonan 31066, Republic of Korea.

Four distinct pore-filling anion exchange membranes (PFAEMs) were prepared, and their mechanical properties, ion conductivity, and performance in anion exchange membrane water electrolysis (AEMWE) were evaluated. The fabricated PFAEMs demonstrated exceptional tensile strength, which was approximately 14 times higher than that of the commercial membrane, despite being nearly half as thin. Ion conductivity measurements revealed that acrylamide-based membranes outperformed benzyl-based ones, exhibiting 25% and 41% higher conductivity when using crosslinkers with two and three crosslinking sites, respectively.

View Article and Find Full Text PDF

Electrodialysis (ED) has already been applied to recover nickel in galvanizing processes, allowing nickel recovery and the production of a treated effluent with demineralized water quality. However, the growth in ED use is still limited by the production and commercialization of ion-selective membranes, currently limited to a few large companies. Therefore, this paper presents the development of homogeneous cationic and anionic membranes made from poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) for ED use.

View Article and Find Full Text PDF

Effect of Anion-Conducting Electrolytes in Pore-Filling Membranes on Performance and Durability in Water Electrolysis.

Membranes (Basel)

December 2024

Department of Green Chemical Engineering, College of Engineering, Sangmyung University, Cheonan 31066, Republic of Korea.

This study examines the effect of the structural characteristics of anion-conducting monomers within pore-filling anion exchange membranes on the performance and durability of anion exchange membrane water electrolysis. Analysis reveals that acrylamide- and acrylate-based membranes show optimal performance without methyl groups, with acrylamide-based membranes outperforming their acrylate counterparts in current density, particularly at 1.8 V.

View Article and Find Full Text PDF

To investigate efficient operating conditions for bipolar membrane electrodialysis (BMED), a comparison of current efficiency () and power intensity () was conducted using different anion-exchange membranes (AEMs) and salt solutions (NaCl and NaSO) as feed solutions in BMED. The results indicated that was higher and was lower for a commercial proton-blocking AEM (ACM) than for a standard AEM (ASE) when NaCl was used. This is because ASE has a higher water content than ACM, leading to greater H permeability, which reduces .

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!