Release of allergens as respirable aerosols: A link between grass pollen and asthma.

J Allergy Clin Immunol

Asthma and Allergy Center, Huntington Medical Research Institute, Huntington Memorial Hospital, Pasadena, CA, USA.

Published: January 2002

Background: Asthma incidence has long been linked to pollen, even though pollen grains are too large to penetrate into the airways where asthmatic responses originate. Pollen allergens found in small, respirable particles have been implicated in a number of asthma epidemics, particularly ones following rainfall or thunderstorms.

Objective: The aim of this study was to determine how pollen allergens form the respirable aerosols necessary for triggering asthma.

Methods: Flowering grasses were humidified and then dried in a controlled-environment chamber connected to a cascade impactor and an aerosol particle counter. Particles shed from the flowers were analyzed with high-resolution microscopy and immunolabeled with rabbit anti-Phl p 1 antibody, which is specific for group 1 pollen allergens.

Results: Contrary to what has been reported in other published accounts, most of the pollen in this investigation remained on the open anthers of wind pollinated plants unless disturbed-eg, by wind. Increasing humidity caused anthers to close. After a cycle of wetting and drying followed by wind disturbance, grasses flowering within a chamber produced an aerosol of particles that were collected in a cascade impactor. These particles consisted of fragmented pollen cytoplasm in the size range 0.12 to 4.67 microm; they were loaded with group 1 allergens.

Conclusion: Here we provide the first direct observations of the release of grass pollen allergens as respirable aerosols. They can emanate directly from the flower after a moisture-drying cycle. This could explain asthmatic responses associated with grass pollination, particularly after moist weather conditions.

Download full-text PDF

Source
http://dx.doi.org/10.1067/mai.2002.120759DOI Listing

Publication Analysis

Top Keywords

respirable aerosols
12
pollen allergens
12
pollen
9
allergens respirable
8
grass pollen
8
asthmatic responses
8
cascade impactor
8
release allergens
4
respirable
4
aerosols link
4

Similar Publications

With the emergence of COVID-19 variants and new viruses, it remains uncertain when the next pandemic will occur. A lockdown is considered the last resort to halt the spread of infection; however, it causes significant economic and social damage. Therefore, exploring less harmful alternatives during such scenarios is crucial.

View Article and Find Full Text PDF

Background/objectives: This study aimed to fabricate, optimize, and characterize nanostructured lipid carriers (NLCs) loaded with trans-resveratrol (TRES) as an anti-cancer drug for pulmonary drug delivery using medical nebulizers.

Methods: Novel TRES-NLC formulations (F1-F24) were prepared via hot, high-pressure homogenization. One solid lipid (Dynasan 116) was combined with four liquid lipids (Capryol 90, Lauroglycol 90, Miglyol 810, and Tributyrin) in three different ratios (10:90, 50:50, and 90:10 /), with a surfactant (Tween 80) in two different concentrations (0.

View Article and Find Full Text PDF

Background: Spray drying, whilst a popularly employed technique for powder formulations, has limited applications for large-scale proliposome manufacture.

Objectives: Thus, the aim of this study was to investigate spray drying parameters, such as inlet temperature (80, 120, 160, and 200 °C), airflow rate (357, 473, and 601 L/h) and pump feed rate (5, 15, and 25%), for individual carbohydrate carriers (trehalose, lactose monohydrate (LMH), and mannitol) for 24 spray-dried (SD) formulations (F1-F24).

Methods: Following optimization, the SD parameters were trialed on proliposome formulations based on the same carriers and named as spray-dried proliposome (SDP) formulations.

View Article and Find Full Text PDF

This study aimed to test the use of Rietveld refinement on respirable aerosol samples to determine the phase of respirable crystalline silica (RCS) and other minerals. The results from the Rietveld refinement were compared to an external standard method and gravimetrical measurements. Laboratory samples consisting of α-quartz, feldspar, and calcite with variable proportions and total mass loadings were made and analyzed using the NIOSH 7500 , followed by Rietveld refinement.

View Article and Find Full Text PDF

Tuberculosis (TB) is the second deadliest infectious disease worldwide. Current TB diagnostics utilize sputum samples, which are difficult to obtain, and sample processing is time-consuming and difficult. This study developed an integrated diagnostic platform for the rapid visual detection of Mycobacterium tuberculosis (Mtb) in breath samples at the point-of-care (POC), especially in resource-limited settings.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!