This study explores the effects of active hip extension moment produced by electrical stimulation on the support forces the arms must exert through an assistive device during quiet erect standing with functional neuromuscular stimulation (FNS) in individuals with spinal cord injuries (SCI). A static sagittal plane biomechanical model of human standing was developed to predict the effects of stimulated hip extension moment and sagittal plane hip angle on the arm support necessary to maintain an upright posture. Two individuals with complete thoracic SCI were then tested while they stood with continuous stimulation to the knee and trunk extensors. The steady-state active extension moment exerted at the hip was varied by activating different combinations of hip extensor muscles with continuous stimulation while steady-state support forces applied to the arms and feet during standing were measured. The steady-state support forces imposed on the arms during quiet standing decrease with increased stimulated hip extension moment and are highly dependent upon hip flexion angle, as predicted by the biomechanical simulations. Experimentally, the combination of gluteus maximus and semimembranosus stimulation produced three times more steady-state hip extension moment than did stimulation of the gluteus maximus and adductor magnus. This resulted in a ten-fold decrease in body weight supported on the arms. More vertical postures (smaller hip flexion angles) improve the effectiveness of the hip extensor muscles in reducing the support forces placed on the arms. A single Newton-meter of stimulated hip extension moment with the hips fixed at 5 degrees of flexion results in almost five times the reduction in arm support forces as with the hips at 20 degrees. To minimize the forces applied by the arms on an assistive device for support while standing with FNS, these preliminary results suggest that (1) efforts should be made to assume the most erect postures possible and (2) muscles and stimulation paradigms that maximize active hip extension moment should be chosen.

Download full-text PDF

Source

Publication Analysis

Top Keywords

extension moment
32
hip extension
28
support forces
24
stimulated hip
16
hip
13
effects stimulated
8
extension
8
moment
8
support
8
active hip
8

Similar Publications

Background: Osoto-gari is a leg throw technique that primarily relies on the hip extension to initiate the sweeping motion of the leg. A high sweep contact velocity is a crucial factor in efficiently executing this technique. While some literature emphasises whole-body coordination in the leg-sweeping action, the roles of trunk and head motion remain unclear.

View Article and Find Full Text PDF

Barbell squats are commonly used in strength training, but the anterior-posterior displacement of the Center of Mass (COM) may impair joint stability and increase injury risk. This study investigates the key factors influencing COM displacement during different squat modes.; Methods: This study recruited 15 male strength training enthusiasts, who performed 60% of their one-repetition maximum (1RM) in the Front Barbell Squat (FBS), High Bar Back Squat (HBBS), and Low Bar Back Squat (LBBS).

View Article and Find Full Text PDF

Background: Patellofemoral pain syndrome (PFPS) is one of the most common conditions affecting the knee joint, yet its pathomechanics remain unclear. The aim of this study was to investigate changes in muscle activation and gait patterns and to analyze the relationship between muscle activation and kinetic gait patterns in patients with PFPS.

Methods: This study included 31 patients with PFPS and 28 healthy volunteers without any symptoms.

View Article and Find Full Text PDF

Background: We aimed to synthesize the kinematics and kinetics during landing and walking/running tasks of ankle copers compared with patients with chronic ankle instability and controls.

Methods: We systematically searched PubMed, CINAHL, SPORTDiscus, and Web of Science. Tri-planar lower extremity biomechanics (joint angle and moment at maximum and initial contact, and joint displacement) were synthesized using standard mean difference and 95 % confidence intervals.

View Article and Find Full Text PDF

Shannon Entropy Computations in Navier-Stokes Flow Problems Using the Stochastic Finite Volume Method.

Entropy (Basel)

January 2025

Faculty of Civil Engineering, Architecture and Environmental Engineering, Lodz University of Technology, 90-924 Łódź, Poland.

The main aim of this study is to achieve the numerical solution for the Navier-Stokes equations for incompressible, non-turbulent, and subsonic fluid flows with some Gaussian physical uncertainties. The higher-order stochastic finite volume method (SFVM), implemented according to the iterative generalized stochastic perturbation technique and the Monte Carlo scheme, are engaged for this purpose. It is implemented with the aid of the polynomial bases for the pressure-velocity-temperature (PVT) solutions, for which the weighted least squares method (WLSM) algorithm is applicable.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!