Transmission electron microscope images were obtained of fractions of poly(1-tetradecene sulfone) and poly(cyclohexene sulfone) cast from very dilute solutions (0.007%, wt/vol) and rapidly freeze-dried on a mica surface. The samples were then vertically platinum-carbon (Pt-C) replicated with 9 +/- 0.3-A Pt-C and held together with 128 A of electron-transparent evaporated carbon. The Pt-C coating enlarges the molecular chain diameters by approximately 5 A, so that a single polysulfone chain has an apparent diameter of 9-12 A in the transmission electron microscope. Poly(1-tetradecene sulfone) forms short helical regions that show irregular helical turns of pitch 7-18 A, two to eight turns long with apparent helix diameters of 16-22 A. The n-C12H25 side chains were not obvious on the helices, but a few were visible on extended chain sections. In contrast, poly(cyclohexene sulfone) appears as a collection of Pt-C-coated single chains 10-12 A in diameter with no side-chain projections. The presence and absence of helical regions in these freeze-dried polysulfones thus reflects their solution conformations as long ago inferred on the basis of dielectric measurements.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC49841 | PMC |
http://dx.doi.org/10.1073/pnas.89.17.7991 | DOI Listing |
Parasitol Res
January 2025
Department of Invertebrate Zoology, Saint Petersburg University, Universitetskaya emb., 7/9, Saint Petersburg, 199034, Russia.
Digeneans of the family Notocotylidae differ from other digeneans in their peculiar eggs. The eggs feature a pair of long filaments extending from their poles, and their contents differ significantly from what we expect to observe in the eggs of digeneans. Instead of a ciliated miracidium larva, the notocotylid egg contains a tiny few-celled mother sporocyst.
View Article and Find Full Text PDFACS Appl Mater Interfaces
January 2025
Univ. Lille, CNRS, Centrale Lille, Univ. Polytechnique Hauts-de-France, Junia-ISEN, UMR 8520-IEMN, F-59000 Lille, France.
The effect of growth temperature and subsequent annealing on the epitaxy of both single- and few-layer TaSe on Se-terminated GaP(111) substrates is investigated. The selective growth of the 1T and 1H phases is shown up to 1 ML according to X-ray and ultraviolet photoelectron spectroscopies. The 1H monolayer, favored at low temperatures, exhibits a very homogeneous coverage after annealing, while the 1T ML, grown at high temperatures, is characterized by a better in-plane orientation.
View Article and Find Full Text PDFNano Lett
January 2025
Wuhan National Laboratory for Optoelectronics, School of Integrated Circuits, Huazhong University of Science and Technology, Wuhan 430074, China.
Recent developments in artificial intelligence and the internet-of-things have created great demand for low-power microelectronic devices. Two-dimensional (2D) electrical switching materials are extensively used in neuromorphic computing technology, yet their high leakage current and low endurance impede their further application. This study presents a vertical crossbar-structured conductive-bridge threshold switching device based on 2D TaSe oxide.
View Article and Find Full Text PDFMater Today Bio
April 2025
Department of Laboratory Medicine, The Third Xiangya Hospital, Central South University, Changsha, 410013, Hunan Province, China.
Purpose: infection is the most common pathogen in burn wound infections, causing delayed wound healing and progression to chronic wounds. Therefore, there is an urgent need to develop antimicrobial agents that can promote wound healing for effectively treating infected wounds.
Patients And Methods: Using magnetic stirring and ultrasound to synthesize Apt-pM@UCNPmSiO-Cur-CAZ.
ACS Sens
January 2025
Department of Physics, National Chung Hsing University, Taichung 402, Taiwan.
Next-generation real-time gas sensors are crucial for detecting multiple gases simultaneously with high sensitivity and selectivity. In this study, ternary metal sulfide (PbSnS)-incorporated metal oxide (SnO) heterostructures were synthesized via a one-step hydrothermal method. Characterizations such as X-ray diffraction, high-resolution transmission electron microscopy, and X-ray photoelectron spectroscopy confirmed the successful formation of PbSnS/SnO heterostructures.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!