Purpose: The purpose of this report is to describe a new technique to fabricate and deliver an implant-supported fixed prosthesis to the patient on the day of surgery, and to propose a protocol for the prosthodontic and dental laboratory procedures.
Materials And Methods: The development of the Brånemark Novum prosthodontic protocol is reviewed, and clinical and dental laboratory assessments and methods are described.
Results: The total treatment time to fabricate a permanent implant-supported fixed prosthesis in the mandible can be reduced to 1 day with the Brånemark Novum technique. The new method includes a precise surgical technique using drilling templates for predetermined implant positions, a rigid splinting of the implants immediately after placement, the use of a prefabricated titanium framework, and elimination of implant impression procedures.
Conclusion: With the technique described in this report, it is possible to provide patients with a permanent implant-supported fixed prosthesis in the mandible on the day of implant surgery. Patient benefits are obvious, with drastically reduced total treatment time, lower cost, and fewer clinical visits.
Download full-text PDF |
Source |
|---|
Publication Analysis
Top Keywords
Similar Publications
Load-bearing capacity of screw-retained fixed dental prostheses made of monolithic zirconia on different abutment designs and abutment-free implant connection.
J Dent
January 2025
Senior Research and Teaching Assistant, Clinic of Reconstructive Dentistry, Center for Dental Medicine, University of Zurich, Plattenstrasse 11, 8032 Zurich, Switzerland. Electronic address:
Objectives: A new abutment-free implant connection allows for direct screwing of FDPs on implants to avoid complications caused by cement rests or screw loosening, which may affect to screw torque and load distribution. The objective of this study was to test the initial (Fi) and final failure (Ff) loads and torque changes of abutment-free monolithic zirconia CAD-CAM fixed dental prostheses (FDPs) compared to titanium FDPs on different abutment designs.
Methods: Three-unit screw-retained FDPs (n=50) on two implants (n=100) were divided into groups (n=10) based on the implant-abutment connection and material of the supra-structure: (1) abutment-free monolithic CAD-CAM zirconia FDP (Abut-free-Zr), (2) abutment-free veneered titanium FDPs (Abut-free-Ti), (3) monolithic zirconia FDPs with titanium base abutments (Zr-Ti-Base), (4) monolithic zirconia FDPs on multi-unit abutments (Zr-MU), (5) veneered titanium FDP on multi-unit abutments (Ti-MU).
Prosthetic rehabiliatation of a hemimaxillectomy patient using a zygomatic - Corticobasal® implant- supported reconstructive prosthesis: A case report.
Int J Surg Case Rep
January 2025
Department of Prosthodontics, RAK College of Dental Sciences, RAK Medical and Health Sciences University, Ras Al Khaimah, United Arab Emirates. Electronic address:
Introduction: Rehabilitation of patients with hemimaxillectomy presents a challenge. This case report describes the successful use of zygomatic Corticobasal® implant- supported reconstructed prosthesis.
Clinical Case Presentation: A 20-year-old female patient presented to the clinic following hemimaxillectomy with soft tissue approximation one year ago.
Debridement Technique for Single-Stage Revision Shoulder Arthroplasty.
JBJS Essent Surg Tech
January 2025
Shoulder and Elbow Service, Florida Orthopaedic Institute, Tampa, Florida.
Background: The incidence of revision shoulder arthroplasty continues to rise, and infection is a common indication for revision surgery. Treatment of periprosthetic joint infection (PJI) in the shoulder remains a controversial topic, with the literature reporting varying methodologies, including the use of debridement and implant retention, single-stage and 2-stage surgeries, antibiotic spacers, and resection arthroplasty. Single-stage revision has been shown to have a low rate of recurrent infection, making it more favorable because it precludes the morbidity of a 2-stage operation.
View Article and Find Full Text PDFPurpose: This retrospective study aimed to compare extended sinus lift and extramaxilla surgical protocols for restoring severely atrophic maxillae with zygomatic implants (ZIs) and evaluate their clinical effectiveness.
Materials And Methods: The study includes patients who were treated at a dental clinic in Italy from 2012 to 2022. These patients received fixed screw-retained complete dentures supported by either two or four zygomatic implants (ZIs).
Fracture resistance and mode of failure of modified Polyether-ether-ketone versus lithium disilicate endocrowns.
BMC Oral Health
January 2025
Department of Fixed Prosthodontics, Faculty of Dental Medicine, Al-Azhar University, Cairo, 11651, Egypt.
Purpose: The current study aimed to compare modified Polyether-ether-ketone's fracture resistance and failure mode versus lithium disilicate glass-ceramic endocrowns.
Materials And Methods: A total of 16 butt-joint endocrown specimens on mandibular second molar teeth were fabricated and divided into two equivalent groups; Pressable modified Polyether-ether-ketone (PEEK) (BioHPP) and Pressable lithium disilicate glass ceramic (IPS e.max Press).
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!