Formulation of trichloroacetic acid peeling solution: a bibliometric analysis.

Since the beginning of this century, trichloroacetic acid solutions of various concentrations have been used for chemical exfoliation. These solutions have been prepared by using four different formulas. To prepare a 50% solution, for instance, water may be added to 50 g of trichloroacetic acid crystals until 100 ml of solution is obtained (weight-to-volume solution). Alternatively, 50 g of water may be added to 50 g of trichloroacetic acid crystals (weight-to-weight solution), or 50 g of trichloroacetic acid crystals may be solved in 100 ml of water (weight-plus-volume solution). Finally, a saturated trichloroacetic acid solution (or "100% solution") may be diluted by an equal volume of water (dilution). Depending on the method used, these so-called 50% solutions contain 40 to 71 weight-to-volume percentages of trichloroacetic acid. From a review of 120 publications on trichloroacetic acid peeling that have appeared since 1926, it was concluded that the authors of 87 of these publications (73 percent) did not report their formula for the trichloroacetic acid solution. Any one of the four methods was reported to have been used by the 33 authors who did report their formula. Eight of 10 internationally reputed pharmacopeias were found not to include the formula of a trichloroacetic acid solution. Proper evaluation of results and prevention of complications of trichloroacetic acid chemexfoliation is only feasible if both the concentration and the formula of trichloroacetic acid solution are reported by the author. Practitioners who use a trichloroacetic acid solution need to establish that the concentration of the solution they apply corresponds with that of the solution reported in the literature.