Experiments in several species have shown that the axial elongation rate of the developing eye can be increased or decreased by manipulating the visual environment, indicating that a visually guided emmetropization mechanism controls the enlargement of the vertebrate eye during postnatal development. Previous studies in tree shrews (Tupaia glis belangeri) suggest that regulation of the mechanical properties of the sclera may be an important part of the mechanism that controls the axial elongation rate in this mammal. To learn whether the mechanical properties of the sclera change when the axial elongation rate is increased or decreased under visual control, uniaxial mechanical tests were performed on 3-mm wide strips of tree shrew sclera. The creep rate was measured under 1, 3, and 5 g of tension, maintained for 30 min at each level. The modulus of elasticity was calculated from the elastic extension that occurred when the force was increased from 0 to 1 g, 1 to 3 g, and 3 to 5 g. Both were measured in the sclera of both eyes from animals exposed to four experimental conditions: (1) Normal development, at intervals from the day of natural eyelid opening (day 1 of visual experience [VE]) to greater than 5 years of age; (2) Monocular form deprivation (MD), for varying lengths of time; (3) Recovery from MD; (4) Monocular -5 D lens treatment. The creep rate was low in normal animals (1-2% elongation/h), did not change significantly between day 1 and day 75 of VE, and was not significantly different between the two eyes. Four days of MD produced a 200-300% increase in creep rate in the sclera from deprived eyes. Creep rate remained similarly elevated after 11 and 21 days of MD. After 2 days of recovery, which followed 11 days of MD, the creep rate of sclera from the recovering eyes was below normal levels. In animals that wore a monocular -5 D lens for up to 21 days, creep rate increased, and then decreased, in concert with the increase, and decrease, in axial elongation rate as the eyes compensated for the lens. The modulus of elasticity of the sclera was not significantly affected by any manipulation. The temporal correspondence between changes in axial elongation rate and changes in creep rate support the hypothesis that regulation of the time-dependent mechanical properties of fibrous mammalian sclera plays a role in controlling axial elongation rate during both normal emmetropization and the development of refractive errors.

Download full-text PDF

Source
http://dx.doi.org/10.1016/s0042-6989(98)00150-3DOI Listing

Publication Analysis

Top Keywords

creep rate
28
axial elongation
24
elongation rate
24
mechanical properties
16
rate
13
increased decreased
12
sclera
9
regulation mechanical
8
tree shrew
8
shrew sclera
8

Similar Publications

The tensile behaviour of paper under high loading rates.

Cellulose (Lond)

December 2024

Vehicle Safety Institute, Graz University of Technology, Inffeldgasse 13/6, 8010 Graz, Austria.

This work deals with the strain-rate dependent characterization of paper under uniaxial tension at high strain-rates. Experiments were performed involving a Split Hopkinson bar for high strain-rate testing, comparing the results with conventional quasi-static tests. Tests were conducted in a strain-rate range between 0.

View Article and Find Full Text PDF

Lithium dendrite penetration through solid electrolyte has been the major obstacle for practical sulfide-based all-solid-state lithium metal batteries (ASSLMBs). Herein, a series of tailored model solid cells are designed to investigate the intrinsic lithium growth behavior at open surfaces and internal cracks of sulfide solid electrolyte. It is shown that when plating lithium on the open surface of electrolyte (free space), the lithium exhibits an intrinsic columnar growth behavior perpendicular to the electrolyte surface, preferentially along the (110) crystal axis.

View Article and Find Full Text PDF

Cell wall extensibility is a key biophysical characteristic that defines the rate of plant cell growth. It depends on the wall structure and is controlled by numerous proteins that cut and/or (re)form links between the wall constituents. Cell wall extensibility is currently estimated by different in vitro biomechanical tests.

View Article and Find Full Text PDF

Comparison of the Performance of Nonlinear Time-Dependent Constitutive Models Calibrated with Minimal Test Data Applied to an Epoxy Resin.

Materials (Basel)

January 2025

CITAB-Centre for the Research and Technology of Agro-Environmental and Biological Sciences, School of Science and Technology, University of Trás-os-Montes and Alto Douro, 5000-801 Vila Real, Portugal.

Epoxy resins are extensively employed as adhesives and matrices in fibre-reinforced composites. As polymers, they possess a viscoelastic nature and are prone to creep and stress relaxation even at room temperature. This phenomenon is also responsible for time-dependent failure or creep fracture due to cumulative strain.

View Article and Find Full Text PDF

Short- But Not Long-Term Effects of Creep Feeding Provided to Suckling Piglets.

Animals (Basel)

January 2025

Departamento de Producción Animal, Facultad de Veterinaria, Universidad Complutense, Avda. Puerta de Hierro s/n, 28040 Madrid, Spain.

Fifty-eight litters (16 from primiparous gilts and 42 from multiparous sows) were used, with a total number of 750 piglets involved in the study. Birth weight was stratified into three groups: low (<1.02 kg; LBW), normal (1.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!